User manual REMINGTON EL-8 107624-01

[. . . ] IMPORTANT: Read and understand this manual before assembling or operating this chain saw. Improper use of saw can cause severe injury. WARNING: When using an electric chain saw, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: READ ALL INSTRUCTIONS. Make sure you read and understand all instructions in Important Safety Information on pages 3 through 5. [. . . ] Make sure cord does not catch on branches or logs during cutting. This chain saw is designed with an extension cord hitch that prevents the extension cord from being pulled loose during use. To use, form a loop with the end of the extension cord, insert loop into slot in rear of handle, and place loop over cord hitch (see Figure 9). Gently pull loop against cord hitch until slack is removed. Plug extension cord into chain saw cord. Do not fell a tree without ample skill or expert help. Keep children, animals, and bystanders away from area when felling a tree. If two or more persons perform bucking and felling operations at the same time, provide ample distance between operations. Provide distance of at least twice the height of tree being felled. WARNING: When felling a tree, be aware of your surroundings. Do not endanger any person, strike utility lines, or cause property damage. If tree strikes utility lines, contact utility company at once. Remove dirt, stones, loose bark, nails, staples, and wire from tree where you will make felling cuts. Tree could roll or slide downhill after falling. Place felling notch on side of tree in direction you want tree to fall (see Figure 12). Follow directions below to create a felling notch. Make lower notch cut as close to ground as possible. Cut 1/3 the diameter of tree trunk (see Figure 12). Note: Always make this horizontal lower notch cut first. If you make this cut second, tree can pinch chain or guide bar. Start upper notch cut the same distance above first cut as first cut is deep. Example: If lower notch cut is eight inches deep, start upper notch cut eight inches above it. [. . . ] The bill of sales or proof of purchase must be presented at the time a claim is made under this warranty. This warranty is extended only to the original retail purchaser. This warranty covers only the parts and labor required to restore this chain saw to its proper operating condition. Warranty parts must be obtained through factory authorized dealers and service centers for this product. [. . . ]