User manual REMINGTON ES-1000

[. . . ] S Close supervision is necessary when this shaver is used by, on, or near children or invalids. S Use this shaver only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer. s Keep the cord away from heated surfaces. [. . . ] These products may be purchased at your local retailer, on our website, or by calling 800-736-4648. To start, use the Beard Lifter comb on a daily basis, even if you don't shave every day, to lift flat curly hairs and set up your beard for shaving. Rub the Beard Lifter over your beard area, across the grain in short back-andforth strokes, applying as much pressure as is comfortable. When you shave, hold the shaver as shown, using short, gentle, up-anddown strokes against the grain of your beard. With the Head Assembly already exposed, brush and blow out the hair clippings from the heads and cutters. For a more thorough cleaning, remove the cutter located inside of each of the heads (see "To Remove Cutters"section), and brush thoroughly. after cleaning , reattach the Hairpocket to the shaver. Important: Because the shaver has two types of head configurations (closed and open), and because the heads and cutters tend to wear and conform to each other over time, it is important to keep them as a matched set. to prevent mixing parts during cleaning , it is recommended to remove , clean , and replace one cutter at a time. Attention: Never put the shaver partially or completely into water. s Daily cleaning of the cutting system is recommended to ensure optimum shaving performance. To clean and lubricate your shaver's cutters and head assembly, apply Remington ® Shaver Saver® Lubricant (SP-4). The lubricant helps remove hair clippings while reducing wear. A quick spray after each shave keeps your shaver operating at peak performance. Do not use an aggressive cleansing agent as this may destroy the shaver coatings. Caution: Do not remove or replace the head assembly while shaver is running, as it may damage the cutting system. S Worn or damaged parts should be replaced with Remington® replacement parts only. Remove the Head Assembly by pulling it away from the shaver body (see Fig. Turn Head Assembly upside down, and place on top of a flat surface. Insert the tip of a screwdriver (or other narrow tip object) into the center bend of the cutter, press down lightly, and gently push sideways to slide the cutter outside the Head (see Fig. To reinsert the cutter, align one of its ends with one of the side openings in the head, compress the cutter spring lightly, and gently slide cutter back into place. You can take your ES-1000 shaver with you when you travel just about anywhere in the world. [. . . ] Service under the Remington warranty can be obtained outside the United States by Remington-Authorized Distributors and Service Dealers. Please consult your local telephone directory for the nearest location. Remington warrants that your product, except as noted below, is, on date of purchase, free from defect in material and workmanship. Remington will correct any such defect without charge if you return the complete product either in person or by mail, postage paid, to a Remington Company-owned Service Center or Authorized Service Dealer within two years after date of purchase. [. . . ]