User manual REMINGTON GCT-2000

[. . . ] S Do not use outdoors or operate where aerosol (spray) products are being used, or where oxygen is being administered. s Always store this appliance and cord in a moisture-free area. Make sure the cord is disconnected from the clipper. To reduce the risk of electric shock: s Do not reach for an appliance that has fallen into water. [. . . ] As you become familiar with the settings, you can then select your desired length setting. Trimmer Guard Attachment NOTE: Trimmer guard must be attached to the clipper in order to use the hair length selector. Remove trimmer guard attachment if you are defining hairline edges such as sideburns, trimming the nape of your neck, trimming your beard line on front of neck, or if you want to clean the cutter assembly. to remove: s Be sure the clipper is in the OFF position. S While holding clipper in one hand and holding the Zoom Wheel to prevent it from turning, gently pull the trimmer guard attachment away from the clipper. The guard can be removed and replaced on any setting. S While holding the clipper in one hand, and holding the Zoom Wheel to prevent it from turning, slide the guard over the top of the clipper until it clicks into position. NOTE: The trimmer guard attachment can only be placed on the clipper one way; if it does not fit properly, remove and reverse it. Allow the clipper to cut through the hair without moving it too quickly. Moving the clipper too quickly may create a pulling sensation. Use short strokes when cutting, and initially use the longest setting. You can always use a closer setting later if you want a closer cut. To cut the hair at the top of the head, hold the hair between your fingers and cut a small amount at a time. To trim around the ears and short hairs at the nape of the neck you must remove the trimming guard. Angle the clipper and lightly stroke around each ear to the back of the neck. Be careful not to touch the ears or to press too hard. The final trim can be made with the hair clipper or the included scissors. Make sure to check over the entire head for any uneven areas. For styled hair or giving quick trims, you may prefer using your hair clipper without the trimming guide. Holding the clipper as shown, lightly stroke upward making sure you are taking off the desired amount of hair. Work your way up to the crown of the head in layers. When completed, comb the area to remove any loose hair and to determine whether you need any further cutting. [. . . ] This warranty gives you specific legal rights, and you may also have other rights that vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above limitations and exclusions may not apply to you. Residents: To order accessories, contact us at 800-736-4648, visit us at www. Canadian residents: To order accessories, please call 800-268-6531 or visit us at www. [. . . ]