User manual REMINGTON HC-600

[. . . ] Do not place or drop into water or other liquid. Do not place or store this appliance where it can fall or be pulled into a tub or sink. Except when charging, always unplug this appliance from the electrical outlet immediately after using. Unplug this appliance before cleaning it. Never drop or insert any object into any of the appliance's openings. [. . . ] Start at the center of the head at the base of the neck. Hold the clipper lightly against the head with the comb teeth pointing upward. Slowly lift the clipper, working upwards and outwards through the hair, trimming just a little at a time. STEP 2 ­ Back of the head ­ Diagram 2 With the 12mm or 18mm Guide Comb attached, cut the hair at the back of the head. STEP 3 ­ Side of the head ­ Diagram 3 With the 3mm or 7mm Guide Comb attached, trim sideburns. Then, change to the longer 9mm Guide Comb and continue to cut the top of the head. STEP 4 ­ Top of the head ­ Diagram 4 1. With the 18mm or 25mm Guide Comb attached, cut hair on top of the head against the direction in which the hair normally grows. For longer hair on top, use without a Guide Comb. Lift the hair on top of the head with a hand comb. Cut over the hand comb with the hair lifted or hold the hair between the fingers and cut it to the desired length. Always work from the back of the head. 3 4 SHORT TAPERED STYLES ­ "FLAT TOPS" & SHORT CUTS 1. Starting with the longest Guide Comb attached (25mm), cut from the back of the neck to the crown. Hold the Guide Comb flat against the head and slowly move the clipper through the hair, as shown. Use the same procedure from the lower side to the upper side of the head, as illustrated. Then cut the hair against the direction in which it grows and level with the sides. To give a "flat top" look, the hair on top of the head must be cut over the top of a flat comb 4. Use a closer Guide Comb to taper the hair down to the neckline as desired. Cleaning & Maintaining Your Clipper AFTER EACH USE High PrecisionTM Hair Clipper is washable enabling use in the shower and ease of cleaning. Therefore, to maintain the performance of the cutters and trimmer, oil lightly before and after each use. Brush or rinse the accumulated hair from the cutters. Place one or two drops of cutter oil on the blades. Turn the clipper on to distribute the oil evenly. [. . . ] For your safety remove the clipper assembly. Using a phillips head screw driver, remove the 2 screws on the back of the fixed blade. Grasp bottom portion of the clipper with one hand and top portion with the other hand. You may need to twist them slightly or use a flat screwdriver to pry them apart. Pull up or pry up on the battery pack and twist to remove it. 8 9 28116_HC-600_IB 9/1/05 10:25 AM Page 10 Performance Guarantee Full Two-Year Warranty Spectrum Brands, Inc. [. . . ]