User manual REMINGTON HC-815

[. . . ] When using an electrical appliance, basic precautions should always be observed, including the following. Read all instructions before using this appliance. S An appliance should never be left unattended when it's plugged in, except when charging a rechargeable appliance. S Close supervision is necessary when this appliance is used by, on, or near children or invalids. [. . . ] See preceding chart to determine which combs your model contains. While the clipper is off, hold the trimming guide with the teeth up. Slide the trimming guide onto the blades until it locks into place. As a safety feature, this plug will fit in a polarized outlet only one way. Do not attempt to defeat this safety feature. Do not wrap the cord around the appliance. S The blades on your HC-810 hair clipper Should be oiled before every haircut. Simply place a few drops of oil on the teeth of the blades. Blades will wear prematurely and not cut properly if they are not sufficiently lubricated. there may also be a pulling sensation on the hair. Oil Cautions s Use only the light-grade oil supplied or a suitable alternative like sewing machine oil ­ these oils will not evaporate and will not slow down the blades. S Do not use hair oil, grease, or any oil mixed with kerosene or solvent, as the solvent will evaporate and leave the thick oil, slowing the blades. Allow the clipper to cut through the hair without moving it too quickly. Moving the clipper too quickly may create a pulling sensation. Use short strokes when cutting, and initially use the longest trimming guide. You can always use a closer trimming guide later if you want a closer cut. If you have the HC-918, HC-920, HC-921, HC-930, or HC-8017 remove the trimming guide and replace with either the left or right ear guide. the shorter guide teeth are designed to be toward the ear. Move the clipper from the front of the head to the back. This creates a tapered effect around the ear and back of the neck. To trim around the ears and short hairs at the nape of the neck with the HC-810 and HC-815, you must remove the trimming guide. Angle the clipper and lightly stroke around each ear to the back of the neck. [. . . ] S Remove the decorative plug from the back cover. S Using a small Phillips head screwdriver, remove the screw from the back of the clipper. Do not burn or mutilate, as they may burst or release toxic materials. Do not shortcircuit, as this may cause burns. [. . . ]