User manual REMINGTON HC5600

[. . . ] 7 Make sure the power plug and cord do not get wet. 8 Do not plug or unplug the appliance with wet hands. 9 Do not use the product with a damaged cord. A replacement can be obtained via our International Service Centres. [. . . ] € Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the head at the base of the neck. € Slowly lift the clipper, working upwards and outwards through the hair, trimming just a little at a time. , STEP 2 – Back of the head • With the comb set at 12mm or 18mm, cut the hair at the back of the head. , STEP 3 – Side of the head • Set the comb to 3mm or 6mm, trim sideburns. Then change the setting to 9mm and continue to cut the top of the head. , STEP 4 – Top of the head • Use the longer length comb attachment and set it to 24mm or 27mm then cut hair on top of the head against the direction in which the hair normally grows. € For longer hair on top, use the longer length comb attachment (24 – 42mm) to achieve the desired style. € Always work from the back of the head. , STEP 5 – The finishing touches • Use the clipper without an attachment comb for close trimming around the base and sides of the neck. € To produce a clean straight line at the sideburns, reverse the hair clipper. Place the reversed clipper at right angles to the head, tips of the blades lightly touching the skin and then work downwards. 6 ENGLISH GB , SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS • Starting with the longest guide comb attached (24 - 42mm), cut from the back of the neck to the crown. Hold the guide comb flat against the head and slowly move the clipper through the hair. € Use the same procedure from the lower side to the upper side of the head. Then cut the hair against the direction in which it grows and level with the sides. € To give a “flat top” look, the hair on top of the head must be cut over the top of a flat comb. € Use a closer guide comb to taper the hair down to the neckline as desired. , DUAL BOOST SYSTEM (HC5600) • There are 3 settings for the Dual Boost system: Off, On, Boost. € If the clipper is set to on, it will run at regular power. • If the clipper is set to boost , it will provide maximum power. , AUTO BOOST SYSTEM (HC5800) • There are 3 settings for the Auto Boost system: Off, Auto, Boost • If the Clipper is set to Auto, it will run at regular power under low load conditions. [. . . ] € Using a small screwdriver, remove (1) screw from the bottom of the clipper. € Pry the front panel from the front housing and expose the inner housing . € Using a small screwdriver, remove (4) screws from inner housing • Pry the cover of inner housing and expose the PCB and batteries. € Cut or break the wire stamps on the both end of the batteries and remove the batteries. [. . . ]