User manual REMINGTON MS-6000

[. . . ] ® MC ® IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be observed, including the following. Read all instructions before using this shaver. Use and Care Guide ® DANGER To reduce the risk of electric shock: Do not reach for an appliance that has fallen into water. Do not use while bathing or in the shower. Do not place or drop into water or other liquid. [. . . ] Completely retracted (down), the mini-foil works with the 2 large screens to provide a close and comfortable shave. Fully extended (up), the mini-foil can be used to provide a close shave for small or difficult-to-reach areas, for a detailed look. Do NOT retract the mini-foil by pressing down directly on the screen. This could permanently damage the screen. Adjusting to your new shaver As with every shaver, your shave will improve over time. So allow about three weeks to develop an effective shaving style and for your beard to adjust to the new shaver. The adaptation period may take a little longer if your skin is sensitive, or if you alternate between shaving methods. To help smooth the transition to your new shaver, a special lubricant has been applied to the shaver's screens and cutters. The lubricant looks like fine white or gray powder, and disappears with use. Before you begin: Wait at least 15 minutes after getting up before shaving, to ensure the face is free of puffiness that may be present E D F from sleeping. (Diagram D) Make sure your face is clean and dry before starting. (Diagram E) Always use a clean, dry shaver. (Diagram F) To shave Push the ON/OFF button. Hold the shaver so both foils touch your face at the same time. (Diagram G) This allows the shaver to work the way it was designed for the closest shave and minimum wear. Avoid holding the shaver at an angle so only one screen touches the skin at a time. This will distort the screen and could cause skin irritation. Use your free hand to stretch your skin. This encourages your whiskers to stand out, making it easier for them to enter the cutting chamber. Pressing only flattens your whiskers, making it harder for them to enter the cutting chamber. It will also wear out the cutting surface more quickly. (Diagram I) Cleaning and Maintenance Cleaning Your Shaver Remington recommends cleaning your shaver after every use for optimal performance. ® 3. [. . . ] To clean the external surfaces of the shaver, use a damp cloth. Daily Blow out the stubble after each shave. Turn the shaver off. This shaving appliance is a washable shaver, the hand-held part of which may be cleaned under water. Disposal 2 1 3 4 5 Questions or comments: Call 800-736-4648 in U. S. Or visit www. remington-products. com 100-240 VAC 50/60 Hz ® Registered Trademark of Spectrum Brands, Inc. , or one of its subsidiaries. [. . . ]