User manual REMINGTON MS2-100

[. . . ] ® IMPORTANT SAFETY INSTRUCTIONS ® When using an electric shaver, basic precautions should always be observed, including the following. Read all instructions before using this shaver. How to get a great shave from your Remington® ® MicroScreen®2 Thank you for buying this premium shaver from Remington® Inside you'll find tips on using and caring for your shaver to get the best shave possible. DANGER To reduce the risk of electric shock: s Do not reach for a shaver that has fallen into water. s Do not use while bathing or in the shower. s Do not place or drop into water or other liquid. s Do not place or store shaver where it can fall or be pulled into a tub or sink. [. . . ] s Gently slide the plastic portion of the cutter assembly over the top of the oscillator tip. s Do not push downward on the ends of the cutters, as you may bend the cutter, reducing its ability to operate smoothly. s Do not remove cutters from the plastic pieces to which they are attached, as you may damage the assembly. Replacing Screens and Cutters Because they are subject to daily use, the cutters and foils of your Remington® MicroScreen® 2 TCT® Shaver will wear and eventually require replacement to maintain a close, comfortable shave. Depending on your shaving technique and habits, the foils will usually last six months; the cutters, one year. Some signs that your foils and cutters need replacing are: s Irritation. As foils get worn, you may notice that your skin feels more sensitive after a shave, particularly when you apply aftershave. As cutters wear, your shave may not feel as close and you may feel your shaver is pulling at your whiskers. You may notice that the cutters have worn through the foil. To prevent inadvertent damage to the Screen and Cutter Assembly, do not attempt to remove them unless you are replacing them. To remove the old screens and cutters follow the instructions that come with the screen and cutter replacement package. It's always a good idea to replace the screens when you replace the cutters. Removing the headguard Before operating your MicroScreen ®2 TCT® Shaver, remove the headguard, which protects the screen and cutter assembly. It is important to remove the headguard correctly to avoid damaging the clips that hold it firmly to the shaver. s Press lightly on the top of the headguard. s Pull the headguard away from the shaver. Charging Prior to using your shaver for the first time, put it on charge for 24 hours. To charge your shaver: s Slide the power button downward to the "Off " position. s Connect the AC power cord to the shaver and then to the electric outlet. A charging indicator light will come on, as described below. s Your shaver cannot be overcharged, so you can leave it plugged in and charging between shaves. s Use only the AC line cord supplied with the shaver. s The MS2-200 is designed for cordless operation only. Plugging in the cord will not power the shaver. s The MS2-300/400 on the other hand, comes with a special feature that allows you to shave while your shaver is plugged in for recharging. [. . . ] MS2-400 Cord and cordless operation, rechargeable with charging, battery level, and low-battery indicator lights, and 1-hour quick charge feature. Worldwide voltage: 100-240 volts, AC 50-60 Hz. 7 Remington warrants that your product, except as noted below, is, on date of purchase, free from defect in material and workmanship. Remington will correct any such defect without charge if you return the complete product either in person or by mail, postage paid, to a Remington Company-owned Service Center or Authorized Service Dealer within two years after date of purchase. [. . . ]