User manual REMINGTON MS2-150

[. . . ] 27714_MS2_150_IB 9/1/05 10:50 AM Page 1 ® ® MC Use and Care Guide MS2-150 27714_MS2_150_IB 9/1/05 10:50 AM Page 2 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be observed, including the following. Read all instructions before using this appliance. WARNING To reduce the risk of burns, fire, electric shock or injury to persons: This appliance is for household use only. An appliance should never be left unattended when it's plugged in, except when charging a rechargeable appliance. Close supervision is necessary when this appliance is used by, on, or near children or invalids. [. . . ] It will also wear out the cutting surface more quickly. Removing the Headguard Before operating your shaver, remove the headguard, which protects the screen and cutter assembly. It is important to remove the headguard correctly to avoid damaging the clips that hold it to the shaver. Press lightly on the top of the headguard. Pull the headguard away from the shaver. 12 9 6 3 !Always keep the protective head guard on the shaver head and keep the trimmer in the OFF position when the shaver is not in use. Always use a clean, dry shaver. 6 7 27714_MS2_150_IB 9/1/05 10:50 AM Page 8 Cleaning & Maintenance Cleaning Your Shaver Remington® recommends cleaning your shaver after every use for optimal performance. Press side release button to flip open head assembly. Screens-Do not use the brush to clean the screens. Instead, blow the shavings out or rinse the screens under cold or warm water. Cutters and trimmer-Use the cleaning brush to sweep any loose hairs from the cutters and trimmers. After cleaning, return the foils and head assembly to their original position on the shaver. To clean the external surfaces of the shaver, use a damp cloth. Do NOT use strong detergents or other chemicals. To dry, wipe the surface of the overall shaver with a dry towel. Do NOT use a hairdryer or heater to dry the shaver. Remove the head assembly by squeezing on both release buttons and pulling up from the body of the shaver. Use the cleaning brush to sweep out the cutters and trimmer. DO NOT USE THE CLEANING BRUSH ON THE SCREENS. Damage may occur to the holes in the screens. Remington® Shaver Saver® Lubricant (SP-4) lubricates and cleans your shaver's cutters and head assembly. The lubricant helps remove hair clippings while reducing wear. A quick spray after each shave keeps your shaver operating at peak performance. Cleaning Cautions The construction of this shaver is for dry operation only. [. . . ] Remove the head assembly by squeezing on both release buttons and pulling up from the body of the shaver. Thoroughly blow out the stubble from the screen and cutters. Weekly Brush out the cutters and trimmer at least once a week. Trimmer Care Cleaning 1. Extend the trimmer to its maximum height by pressing the right trimmer button. [. . . ]