User manual REMINGTON NE-3

[. . . ] If for any reason, within 30 days of the purchase of your Remington Precision Trimmer, you are not satisfied and would like a refund, just return your product, together with the sales receipt to the retailer from whom you purchased it. Remington will reimburse all retailers who accept the product within 30 days of purchase. If you have any questions regarding the money back guarantee, please call 1-800-736-4648 in the United States or 888-277-6333 in Canada. [. . . ] Authorized Service Dealers may be found in the yellow pages of your directory. If you wish, you may mail the product postpaid to Remington Products Company, L. All implied warranties including but not limited to implied warranties of fitness and merchantability, are limited in duration to two years from date of original purchase. Compartment cap approximately one quarter turn then pull off (Figure 2). Label on inside of battery compartment shows proper direction to insert battery in the unit. ⷠPlace cap back on unit in same position as removed and rotate clockwise until the cap snaps into place, and markings align. Use of any batteries other than alkaline will negatively affect the unit's operating performance. Batteries should not be left in the unit, if the unit is not in use for long periods. To prevent battery corrosion the unit should be kept in a dry environment. Dead batteries should be removed immediately and disposed of properly. Do not use batteries that have been recharged with this unit. the lower voltage in recharged batteries impairs the performance of the cutting unit. The upper body of Model NE-3 can flex for added comfort in use. With the switch facing you, tilt the top half forward or backward as desired up to 30° in either direction. Your Remington® Wet/Dry Nose & Ear Trimmer is designed to give you years of comfortable use. To ensure that you get optimal performance from your trimmer, follow these maintenance tips: · Clean your trimmer between uses. [. . . ] Blow out accumulated hair or rinse more thoroughly under running water. ⷠShake excess water from the cutter head, making sure that all parts are held together. ⷠReplace the cutter in the same position as it was removed, rotating it clockwise 1/8 turn to lock it into place. [. . . ]