User manual REMINGTON PG-250

[. . . ] When using an electrical appliance, basic precautions should always be observed, including the following. Read all instructions before using this appliance. An appliance should never be left unattended when it's plugged in, except when charging a rechargeable appliance. Close supervision is necessary when this appliance is used by, on, or near children or invalids. [. . . ] Use short controlled strokes to shave around your beard and mustache while your free hand stretches your skin. This encourages your whiskers to stand out, making it easier for them to enter the cutting chamber. The MiniScreen attachment was not designed to shave your entire face. For a close, comfortable shave, guaranteed, use a Remington-brand electric shavers. Ear canal What to use: nose/ear trimmer head Turn the groomer on. Gently insert groomer's cutting unit into the outer ear canal. For safe trimming, avoid inserting the groomer more than 1/4 inch into the ear canal. Rotate the groomer in a circular motion, gently moving it in and out as you rotate. Outer ear What to use: nose/ear trimmer head Turn the groomer on. Carefully guide the groomer around surfaces of the ear where there are unwanted hairs. Since all hairs do not grow in the same Direction, you may want to try trimming upwards, downwards, or across. What to use: wide trimmer head + comb attachment Attach the desired hair length comb to the groomer head as described on the previous page. set the comb to the desired trim length. It's usually a good idea to use a longer setting until you are familiar with the groomer, to avoid trimming too much hair. Start under your chin and, following your jaw line, trim toward your ear and upper beard line using an upward motion. Allow the comb attachment to follow the contours of your face. thinning and tapering (30mm) What to use: wide trimmer Turn the groomer on. Use a small comb to hold the beard hairs in place while trimming. Holding the groomer with the cutting unit facing away from you, move the groomer along the length of the comb. What to use: nose/ear trimmer head Turn the groomer on. Carefully guide the cutting edges to the stray hairs along the eyebrow line or protruding from the eyebrow itself. For best results don't use the groomer to define the entire eyebrow. [. . . ] The RBRC® program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. Please call 1-800-8-BATTERYSM for information on Ni-Cd battery recycling and disposal bans/restriction in your area. 's involvement in this program is part of our commitment to preserving our environment and conserving our natural resources. Remove head and shake out the clippings Blow off cutter assembly. [. . . ]