User manual REMINGTON R-3130

[. . . ] Close supervision is necessary when this appliance is used by, on, or near children, or individuals with special needs or certain disabilities. Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Spectrum Brands, Inc. Never operate this appliance if it has a damaged cord or plug or if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water. [. . . ] Shave face and neck using short, circular strokes. Ensure your skin is dry and free of oils. Wait at least 15 minutes after getting up before shaving, to ensure your face is free of puffiness that may be present from sleeping. Always hold the shaver at a right angle to the skin so that all three heads are touching the skin with equal pressure. Stretch skin with the free hand so hairs stand upright, making it easier for them to enter the cutting chamber. Use moderate to slow, circular stroking movement. The use of short, circular motions in stubborn areas may obtain a closer shave, especially along the neck and chin line. Do not press hard against the skin in order to avoid damage to the rotary heads. **Remington recommends that you use your new shaver daily for up to four weeks to allow time for your hair and skin to become accustomed to the new shaving system** Pull trimmer release button down to engage trimmer. Close trimmer by pressing down on trimmer housing. NOTE: **When cleaning your shaver, make sure the shaver is turned off and disconnected from the power cord. To clean the external surfaces of the shaver, use a damp cloth. Do not use strong detergents or other chemicals. To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer or heater to dry the shaver. Ensure that the main body of the shaver remains dry at all times. (Diagram L) Place the body of the shaver aside to ensure that it will not get wet. (Diagram N) Then rinse and dry the cover thoroughly. Lubricate each cutter with household oil. Grasp plastic case around outer corner and rotate toward the dot on the shaver head. Pull outer cutter up and off of the head assembly and remove inner cutter. Replace outer cutter by lining up the locator with the small dot. [. . . ] If the product should become defective within the warranty period, we will replace it free of charge. Return your product and sales receipt with your name, address and day time phone number to: Remington Returns Center, 507 Stokely Dr. For more information call 800-736-4648 in the US or 800-268-0425 in Canada. warranty excludes: Heads and cutters KEEP ORIGINAL SALES RECEIPT AS PROOF OF PURCHASE FOR WARRANTY PURPOSES. [. . . ]