User manual REMINGTON R-400

[. . . ] Do not place or drop into water or other liquid. Do not place or store this appliance where it can fall or be pulled into a tub or sink. Except when charging, always unplug this appliance from the electrical outlet immediately after using. Unplug this appliance before cleaning it. Never drop or insert any object into any of the appliance's openings. [. . . ] Plugging it in will not provide the power to shave. Cordless Operation of the R-400 Remove the AC power cord from the electrical outlet, then remove from shaver's power port. To activate the shaver, slide the power button up to the ON position. Corded Operation of the R-200 and R-225 Slide the power button down to the OFF position. Connect the supplied AC power cord to the shaver's power port and then to an electrical outlet. To activate the shaver, slide the power button up to the ON position. Charging the R-400 Before using your shaver for the first time, charge it for 24 hours. NOTE: It may take up to 3 cycles of full charge and discharge to maximize battery capacity. To charge your shaver Slide the power button downward to the OFF position. Connect the supplied AC power cord to the shaver's power port and then 6 to an electrical outlet. The Easy-View pop-up trimmer extends to trim mustache, sideburns, etc. Trimmer is turned off until it is extended for use. Push the trimmer button up to pop up the trimmer. Hold the shaver with the trimmer toward you when trimming. After trimming, pull the trimmer button downward into the OFF position. Leave it in the down position when not in use. NOTE (R-400): It is important to always use the button to close the trimmer to avoid damaging the locking mechanism. Operating the Easy-View® Trimmer ® To Trim Trim mustache Use the shaver heads to trim the lower edge of your mustache. Hold shaver at desired trim line for a quick, easy, professional trim. Use the pop-up trimmer for the upper edge of your mustache. Extend the trimmer and touch the edge of it to the desired line. Trim sideburns Extend the trimmer and touch the edge of it to the desired trim line. To Shave Slide the ON/OFF button to activate the shaver for shaving. Hold the shaver so all the heads touch your face together. This allows the shaver to work the way it was designed for the closest 7 Microflex R_200_400_IB 8/24/06 2:34 PM Page 8 Cleaning and Maintenance To assure smooth, efficient performance, it is important to clean your shaver. Lubricate Remington® Shaver Saver® Lubricant (SP-4) lubricates and cleans your shaver's cutters and head assembly. The lubricant helps remove hair clippings while reducing wear. A quick spray after each shave keeps your shaver operating at peak performance. !Important: Make sure to align the two locating holes in the Cutter Retainer assembly with the pins in the Head Frame Assembly. [. . . ] DISPOSE PROPERLY IN ACCORDANCE WITH YOUR LOCAL AND STATE REQUIREMENTS. The EPA-certified RBRC® Battery Recycling Seal on the nickel-cadmium (Ni-Cd) battery indicates Spectrum Brands, Inc. is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. The RBRC® program provides a convenient alternative to placing used Ni-Cd batteries into the trash or the municipal waste stream, which may be illegal in your area. [. . . ]