User manual REMINGTON S-6500

[. . . ] Do not use outdoors or operate where aerosol (spray) products are being used, or where oxygen is being administered. Do not let eyes or bare skin touch heated surfaces. Do not place the heated unit directly on any surface while it is hot or plugged in. The plug on this appliance has one blade wider than the other, it is a polarized plug. [. . . ] Plug the styler into an electrical outlet. Press and hold the ON/ OFF button until the unit turns on. Adjust the temperature using the +/- buttons. 4 Divide hair into manageable sections and clip the upper layers on top of your head and out of the way. Test the styler on a small section of hair, then adjust the temperature up or down before styling the rest of your hair. NOTE: If you find that you need a higher setting while straightening your hair, simply adjust the temperature by pressing the "+" button for two seconds. While straightening your hair, if you find that you need a lower setting, adjust the temperature by pressing the "-" button. Please note, because the unit is already hot, it may take a few minutes to cool off. Take a small section of hair and pull hair down and away from your scalp, and hold hair taut. Starting at the roots, clamp hair firmly between the plates and run the styler down the entire hair strand, from root to tip, in one smooth stroke. Do not hold it in one area for a long period of time, or damage to hair may occur. To create curves or flicks, rotate your wrist to turn the iron in toward your head or out away from your head as you run the iron down the hair strand. Repeat with all the sections of your hair, working with the underneath layers first, then the top and sides to finish. 10. When you are finished styling, press and hold the ON/OFF button for a few seconds to turn the unit off, unplug it, and allow it to cool before storing. NOTE: Make sure the switch lock function is unlocked or the unit will not turn off. NOTE: DUAL VOLTAGE USE This appliance contains a special electronic circuit that automatically converts it for worldwide usage-from 120 to 240 volts AC, 50 to 60 Hz. Plug it into the local outlet and use it as normal; the styler will automatically adjust to the local current. (You may need an adapter to allow the plug to fit into the local outlets. ) DUAL VOLTAGE APPLIANCE Confirm the voltage available at each overseas location before using the appliance. For connection to a 240-volt supply, use an attachment plug adapter of the proper configuration for the power supply receptacle. MAINTENANCE Cleaning Make sure the unit is unplugged and cool. Use a damp cloth to clean the plates and the outside of the power handle. No other maintenance of the unit is required. This appliance has no user serviceable parts. SPECTRUM BRANDS, INC. [. . . ] T22-30221 +/During heat-up time, the LCD blue backlight & temperature setting display turns on. The blue backlight and three bars will pulse until the temperature is stable. The backlight will stay lit and all four bars will show when the unit is ready. Turbo Boost: (hold time about 2 seconds) ­ Activating: Press "+" Button and hold about 2 seconds to increase temperature to maximum 410°F setting instantly, no matter what setting it is. [. . . ]