User manual REMINGTON S-8000I WIDE PLATE STRAIGHTENER

[. . . ] s Do not use an extension cord or a voltage converter with this appliance. s The plates of this appliance are hot when in use. Do not let eyes and bare skin touch heated surfaces. s Do not place the heated unit directly on any surface while it is hot or plugged in. s This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized outlet only one way. [. . . ] Teflon® coating: Non-stick Teflon® coating glides through any type of hair, preventing static, stickiness, and build-up of mousses, gels, and hair sprays for smooth, shiny results ­ every time. 2. Ceramic coating: Ceramic protects against damaging hot spots with high, even heat to lock in moisture and create long-lasting styles. 3. Ionic conditioning: Negative ions are created, neutralizing positive ions to reduce static and the frizzies, leaving your hair looking shin y and healthy. (J) (D) (H) (I) (E) (F) (G) (K) 4 5 How to Use Heat Settings Take extra care when using a professional styler. To prevent hair damage, make sure to use the correct temperature setting for your hair type. Usage Tips Straightening Your Hair 1. Gently towel dry hair to remove excess water. Avoid rubbing hair with a towel, as this creates split ends and frizziness. Plug the straightener into an electrical outlet. Press and hold theON/OFFbutton until the unit turns on and the LCD lights up. The straightener will initially heat to setting 15. Adjust the temperature using the +/- buttons. The bars on the LCD will flash while the unit heats up, then glow steadily when it has reached the selected temperature. The styler will beep three times when it is ready for use. Divide hair into manageable sections and clip the upper layers on top of your head and out of the way. Test the styler on a small section of hair, then adjust the temperature up or down before styling the rest of your hair. NOTE: s If you find that you need a higher setting while straightening your hair, simply adjust the temperature by pressing the "+" button. The unit will beep when it reaches the new temperature. s While straightening your hair, if you find that you need a lower setting, adjust the temperature by pressing the "-" button. Because the unit is already hot, it may take a few minutes to cool off. It will beep when it cools to the lower temperature. Take a small section of hair and comb through it with a fine-toothed comb. Pull hair down and away from your scalp, and hold it taut. Hold the straightener with the LCD and steam vents facing away from your scalp. Starting at the roots, clamp hair firmly between the plates and run the styler down the entire hair strand, from root to tip, in one smooth stroke. Do not hold it in one area for a long period of time or damage to hair may occur. [. . . ] 120-240 VAC 50-60 Hz Questions or comments: Call 800-736-4648 in U. S. Or visit www. remington-products. com Remington and wet2straight are trademarks of Rayovac Corporation. Teflon is a registered trademark of E. I. du Pont de Nemours Company and is used under license by Rayovac Corporation. Patent Pending ©2004 R. C. Error Messages rE Your straightener will display an "rE"message if it has a recoverable error or malfunction. If this happens, turn the unit off, unplug it, and allow it to cool for 10 ­15 minutes. Then plug it in and turn it on again. [. . . ]