User manual REMINGTON TA5570

[. . . ] When using an electric shaver, basic precautions should always be observed, including the following. Read all instructions before using this shaver. How to get a great shave from your Remington ® MicroScreen® 3 Shaver Thank you for buying this premium shaver from Remington ®. Inside you'll find tips on using and caring for your shaver to get the best shave possible. [. . . ] The first foil sets up the beard so that more hairs enter the cutting chamber of the second foil where they are cut just below the level of the skin. The third foil helps give you an extra-close shave. Here are a few tips for getting the closest shave possible: Always use a clean, dry shaver. Tip: To help reduce wear and tear, spray the foils and head assembly with Remington® Spray Shaver-Saver® Lubricant after every shave. This helps remove hairs while keeping your shaver operating smoothly. To help maximize your shaver's performance, consider using the Remington® Pre-Shave Powder Stick (SP-5). It absorbs moisture and facial oils, helping set up the hairs so they enter the cutting chamber more easily. It makes shaving quicker and more comfortable. The trimmer on your Remington® MicroScreen® 3 Shaver is easy to maintain. S When you clean your shaver, just brush off any clippings that may accumulate around the trimmer Assembly. Using the longer bristles on the brush supplied will enable you to get into the area between the trimmer and the shaver. Wait at least 15 minutes after rising to allow the puffiness that most men experience upon waking to disappear. S Every six months, lubricate the trimmer teeth by applying a drop of light machine oil one-third and two-thirds of the way along the blade. Using your finger tip, spread the oil along the teeth, and run the trimmer for a few seconds. Before operating your MicroScreen® 3 Shaver, remove the headguard, which protects the foils and cutter assembly. When approximately two shaves remain, the LED will change from AMBER to RED. S If your TA-4570/5570 shaver battery is completely discharged or the shaver has not been used for an extended period of time, the shaver may not start when operated using the cord. If this condition occurs, charge the shaver for approximately five minutes before shaving. S Your TA-4570/5570 cord/cordless shaver should not be used strictly as a cord-operated shaver, as continued cord only use will result in reduction of battery life. S In order to preserve the life of the batteries, they should be fully discharged every six months and then fully charged for 24 hours. Because they are subject to daily use, the cutters and foils of your Remington® MicroScreen® 3 Shaver will wear and eventually require replacement to maintain a close, comfortable shave. Depending on your shaving technique and habits, the foils will usually last six months; the cutters, one year. [. . . ] s Pull or gently pry the shaver halves apart , exposing the battery. S Lift the rubber Side Panels from their cradles and put them aside. S Hold each battery in place and very carefully slide the clips from the terminals on each batter y. " s Gently place the forked legs into the opening at the top of the oscillator tips. [. . . ]