User manual REMINGTON TLG-100

[. . . ] Allow the hair length attachment to follow to contours of your face. When finished trimming, turn the unit's power switch to OFF. tO TRIM EDGE OF MUSTACHE Remove hair length attachment. Mustache hairs should be dry and avoid any waxes or lotions before using trimmer. [. . . ] To fasten the hair length attachment, place the front hooks on the hair length attachment over the front of the groomer's trimmer head and pivot onto backside of the groomer's trimmer head to lock into place. To remove, push up on tab on back of hair length attachment. You will need a hand mirror for this operation if performing it alone. The mirror is not necessary if trimming is performed by a second person. Use your fingers to lift the hair at the base of your head up off the neck. Your index finger should be covering the roots of the hairs you are lifting to prevent accidental removal by groomer. Using your other hand, hold groomer horizontally to the base of your neck with the cutting unit facing up, and move the groomer along the length of the neck until the unit touches your finger covering the hair roots at the base of your head. Repeat this procedure for the entire area of the neck. Be sure to move the unit slowly when performing this operation and to keep the hair roots at the base of your head out of the way of the groomer. Use the hand mirror to inspect the results of the operation and ensure all hairs along the nape of the neck have been trimmed. Do not use while bathing or in a shower. Do not place or store groomer where it can fall or be pulled into a tub or sink. Do not place in drop into water or other liquid. Close supervision is necessary when this appliance is used on or near children or invalids. Use the groomer only its intended use as described in this manual. Do not use attachments not recommended by the manufacturer. Never operate this groomer if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the groomer to a service center for examination and repair. Never drop or insert any object into any opening. Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered. Do not use this groomer with a damaged or broken cutting unit, as facial injury may occur. Always store your groomer in a moisture-free area. [. . . ] Use unit's styling comb or a small comb to comb and hold the beard hairs in place while trimming. Hold the groomer with the cutting unit facing away from you, move the groomer along the length of the comb. Clean and lubricate your groomer regularly to insure your unit's operating life is not prematurely shortened. Do not apply pressure or hard objects to cutters. [. . . ]