User manual REMINGTON WR-5000

[. . . ] Do not place or store this appliance where it can fall or be pulled into a tub or sink. Except when charging, always unplug this appliance from the electrical outlet immediately after using. Unplug this appliance before cleaning it. Do not use an extension cord or a voltage converter with this appliance. [. . . ] The adaptation period may take a little longer if your skin is sensitive, or if you alternate between shaving methods. Before you begin: Make sure your legs are clean before starting. You can use your free hand to stretch your skin. This encourages your hair to stand out, making it easier for them to enter the cutting chamber. It is not necessary to apply pressure while shaving, just let the shaver glide lightly on your skin. Pressing only flattens your hairs, which makes it harder for them to enter the cutting chamber. It will also wear out the cutting surface more quickly. A gentle touch makes shaving easier and helps avoid possible skin irritation. Using Shaver with Soap or Foam Lather When using soap or foam lather, the shaver will glide smoothly over the skin, cleaning away oil residue while at the same time leaving skin soft and smooth. Apply the soap or foam generously to the skin. Do not use skin lotion, nourishing cream, or shaving cream of the non-lathering type. Shaver should be cleaned after using soap or foam. Caution: Not recommended use on head, underarms or any other parts of the body. The replacement parts for your shaver is model SP-25. & Canadian residents: To order, contact us at 800-231-8793, visit us at www. remington-products. com or visit your local retailer. Cleaning and Maintenance To assure smooth, efficient performance, it is important to clean your shaver. Daily Brush inside the head assembly after each use: 1. Grip the head assembly by the three ridges and pull it off the shaver. Use the cleaning brush to sweep out the internal part of the head assembly and the hair pocket area, where 3 shaver spindles are located. Replace head assembly. Replace head assembly on the shaver simply by pushing it onto the shaver. Cover shaver head with plastic headguard between uses. When removing the headguard or placing it back onto the shaver, do not apply pressure to floating cutter surfaces, as you may damage them. Cutter retainer assembly Center screw knob Locating holes Head/frame assembly Floating cutter heads Locating pins Weekly Clean under the cutter assembly at least once a week: 1. Unscrew the center screw knob 1/4 of a turn to remove the cutter retainer assembly. Use the cleaning brush to sweep the dust and hairs from under the cutters. [. . . ] 120 VAC, 60 Hz REMINGTON and SMOOTH & SILKY are trademarks of ROVCAL, INC. Questions or comments: Call 800-736-4648 in U. S. Or visit www. remington-products. com Dist. by: Spectrum Brands, Inc. , Madison, WI 53711 Dist. [. . . ]