User manual REMOTEC BW0378

[. . . ] Remove the battery cover on the back of your URC. If the indicator flashes twice slowly after your invoking of any command, it shows that the battery level is low. You must replace them with new batteries to ensure proper functioning. You may setup the URC by the following code entering instructions. [. . . ] ­ You are recommended to jot down your Device Codes in the space provided on back label after setting up the URC correctly for future reference. If you cannot identify a correct Device Code for your equipment from the Device Code list, you may search the code through the library:1. Hold down " P+ " and " VOL­ " on the URC together simultaneously for 2 seconds until the indicator lights up. Enter a corresponding Magic Search Code from following table. The indicator should go out immediately. Press TV device mode key, then press " P+ " and " VOL­ " , and enter TV Magic Search Code 0001. Press the same desired device mode key again as in step 2 above. Hold down " P+ " & " VOL­ " together simultaneously for 2 seconds until the indicator lights up, and your URC is ready to start searching. TV), press the " " key repeatedly, slowly and patiently until the device has been turned off. Once your device has been turned off, immediately press " P+ " and " VOL­ " to lock in code and the indicator should go out. * Simply repeat the above setup procedures to search the Device Code for your SAT, DVD or CTV. (Remember to press a correct Device Mode Key and correct Magic Search Code in step 2-5 above) IMPORTANT: ­ If the power on/off function of your device is not infra-red controlled - you need to follow steps 2 to 6 above and start searching :· Press " " and another important function key alternately until your device responds to the expected function, press " P+ " and " VOL­ " to lock in the code. Note: ­ DVD, CTV and SAT can be searched and locked into any device modes except "TV" mode. Just simply press the corresponding device mode key in step 2 & 5 and enter an appropriate Magic Search Code for your DVD, CTV and SAT. ­ Each time you press the " ", the URC will skip to the next code and send out a POWER signal trying to turn off your device. If you failed to stop pressing " " in time when your device has been turned off, turn on your device again immediately. Before the indicator goes out, press " " on the URC to skip backward. Repeat the step 7 above and lock in code. ­ If the indicator flashes twice after your pressing of " " key, you are already at the last code of the library. Press " P+ " and " VOL­ " to resume the URC and repeat carefully the above procedures to search again. [. . . ] Check whether you have pressed the corresponding device mode key for your device. If several Device Codes listed under the brand of my A/V device, how can I select the correct Device Code?To seek the correct Device Code for your A/V device, test the code one by one until most keys work properly. My A/V equipment responds only to some of the commands. [. . . ]