User manual RENKUS-HEINZ D26

[. . . ] S O U N D S C I E N C E Model D26 Digital System Controller Owner's Manual Rev. 2 This equipment has been tested and found to comply with the following European and international Standards for Electromagnetic Compatibility and Electrical Safety: Radiated Emissions (EU): EN55013 (1990) Associated Equipment RF Immunity (EU): EN50082/1 (1992) RF Immunity, Fast Transients ESD Mains Disturbance (EU): EN61000/3/2 (1995) Electrical Safety (EU): EN60065 (1993) Radiated Emissions (USA): FCC part 15 Class B Electrical Safety (USA): UL813/ETL (1996) Commercial Audio Equipment Electrical Safety (CAN): UL813/ETLc (1996) Commercial Audio Equipment IMPORTANT SAFETY INFORMATION DO NOT REMOVE COVERS. NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. IT SHOULD NOT BE NECESSARY TO REMOVE ANY PROTECTIVE EARTH OR SIGNAL CABLE SHIELD CONNECTIONS TO PREVENT GROUND LOOPS. [. . . ] Use the Parameter LEFT/RIGHT keys to select a parameter to adjust. Moving to a new menu may not bring up the first screen shown in each row, as the D26 remembers, and moves you to, the last screen accessed in each menu. Store and Recall are accessed by pressing their respective keys. After powering up, the D26 performs internal checks and sets up the audio path before releasing the output mute relays. This takes a few seconds. Default Screen When the D26 is powered up the Default Screen is shown. This shows the current program name and number. Utilities Menu Pushing the RIGHT key while viewing the default screen will move you into the Utilities menu. The RIGHT and LEFT keys are used to move along the 'Utilities' path, and the Parameter UP/DOWN keys are used to change the selected parameter. Stereo link This mode selects whether parameters will be adjusted together, or independently on each channel. The stereo link pairs in 2 channel 3 way are 1 & 2, 3 & 4 and 5 & 6. The stereo link pairs in 3 channel 2 way are 1 & 3, and 4 & 6. Pushing the Parameter UP/DOWN keys selects Stereo Link: ON and OFF. Configuration Delay units This selects the units used for displaying and adjusting delays. 'ms' represents milliseconds, 'ft' represents feet (and feet and inches for short delays), and 'm' represents metres. Lock out The Lock Out mode prevents access to editing functions on the input and output channels. Since this utility is not password-protected, Lock Out can still be accessed and turned off. This mode is intended only as a precaution against accidental adjustments, and not as a tamper-proof security lock. MIDI channel Here, you can select the MIDI channel that the unit is assigned to (Channels 1 through 16 are available). Contrast This allows you to change the contrast of the LCD display. (Turn to) MIDI dump This mode allows you to dump the current program settings to another D26, or a MIDI storage device for backup. The default position for this screen is MIDI DUMP: NO. Use the Parameter UP/DOWN keys to select YES will ask you to press STORE to confirm the dump. [. . . ] Once the program name has been entered, and the Program lock status cleared, pressing the STORE key again will prompt the message "STORE UNLOCKED?", asking whether the program should be stored with a Program lock on/off. Use the Parameter UP/DOWN keys to turn the Lock on/off, the default setting being ON. Once the Lock status is set, push the STORE key a final time to commit the program to memory. The display will now default back to the screen displayed before the STORE facility was accessed. [. . . ]