User manual REVEL ULTIMA GEM2 TEMPLATE

[. . . ] ® STUD Wall-Mount Template CEILING WALL-MOUNTING INSTRUCTIONS The Ultima Gem®2 loudspeaker can be mounted to a wall or the optional pedestal. The following instructions provide detailed information regarding how to mount the loudspeaker on a wall in your listening room. [. . . ] Note: For safety purposes, the loudspeaker must be centered on a wall stud when mounted. Step 2: Retrieve the wall-mount template, found in the accessory bag that was shipped with the loudspeaker. Step 3: Tape the template to the wall, centering the drill holes over a wall stud. Ensure that the bracket distance is at least 15. 5" (394 mm) from the edge of the ceiling. Note: The two vertical holes in the center of the bracket template are the holes that are used for wall-mounting the loudspeaker to the stud. 15 1/2 inch MIN. Step 4: Use a level to verify that the bracket tilt is zero and then drill two 1/16" (1. 58 mm) diameter pilot holes. Step 5: Retrieve the wall bracket from the plastic accessories bag that shipped with the loudspeaker. Step 6: Remove the template from the wall. Step 7: Place the wall bracket flat against the wall so that the drilled holes in the wall line up with the wall bracket holes. Be sure to position the bracket so that the out-thrust tabs are on the bottom end. These are the stops that keep the speaker from sliding off the bracket. Step 8: Secure the wall bracket in place with two screws. The minimum required size of the screws is #10 (up to a maximum of 1/4") x 2-1/2" long. [. . . ] Slide the loudspeaker onto the bracket from above, as shown. Make sure the brackets are firmly mated before releasing the loudspeaker. CABINET BRACKET WALL BRACKET STUD Harman Consumer Group, Inc. , Northridge, CA USA © 2007 Harman International Industries, Incorporated. [. . . ]