User manual REVEL ULTIMA GEM2 PEDESTAL UNPACKING INSTRUCTIONS

[. . . ] Revel® Ultima Gem®2 Pedestal Unpacking Instructions Thank you for purchasing the Ultima Gem®2 Pedestal for your Revel® Ultima Gem®2 Loudspeaker. Follow the instructions below to unpack the pedestal. UNPACKING Step 1: Place the packing carton down so that the long side of the carton that's marked "Open this Side" is facing up. Step 2: Open both the outer box and inner box so that one side of the packaged pedestal is exposed. [. . . ] Select the appropriate end of the spikes/glides depending on your surface. If the speaker is to be used on a hardwood floor or smooth surface use the glide end of the spike. Locate the four threaded insets on the bottom of the pedestal. Felt Washer Locking Ring Spike End Down Step 1: Lay the Ultima Gem®2 pedestal down, face up, on a soft non-scratch surface. Step 2: Find and remove the four Phillips pan-head screws from the accessories bag that was removed from the end pad during the unpacking procedure. Step 3: Remove the wall mount bracket from the loudspeaker accessories kit. This bracket is the matching half of the bracket that is installed on the back of the loudspeaker. Step 4: Place the bracket flat against the front of the inset area of the pedestal, so that the screw holes line up between the pedestal and the bracket. Be sure to position the bracket so that the out-thrust tabs are on the bottom end. These are the stops that keep the speaker from sliding off the bracket. Step 5: Secure the bracket in place with the four Phillips pan-head screws. Be sure to use the outer holes for the screws, leaving the two center holes empty. Tighten the screws firmly but do NOT over-tighten. Step 6: Lay the pedestal face down on a soft non-scratch surface, so that the back of the pedestal is facing up. Step 7: Install the combination spikes/glides with the felt washers and knurled locking rings to the bottom of the pedestal. Hand-tighten the spikes firmly, but do NOT over-tighten. Step 8: Put the cables for the loudspeaker in the hole located on the rear of the pedestal near the bottom and then feed the cables through the pedestal so that they come out at the top end on the front of the pedestal. 2. [. . . ] Make sure that th e brackets are firmly mated before moving the pedestal back to an upright position. Step 10: Adjust the combination spikes/glides to level the speaker as required. Hand-tighten the locking rings after adjustment. Customer Service Tel 781-280-0300 Fax 781-280-0495 (Sales) Fax 781-280-0499 (Service) Harman Specialty Group 3 Oak Park Drive Bedford, MA 01730-1413 USA Tel 781-280-0300 Fax 781-280-0490 www. revelspeakers. com Revel Part No. [. . . ]