User manual REX CA962ALU

[. . . ] Uso . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Manutenzione . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] 5b-c) air outlet to the right or left hand side, must be marked at a distance X from the line between holes 1, obtained by measuring the extension Z of the chimney required for installation, plus 18 mm X=Z+25-7. Using a Ø8 mm drill bit, drill the points marked in this way. 5a 5b 5c 50 ø1 0 7 ø1 2 105 105 2 Z X 2 1 1 1 2 1 1 1 39 100 100 ø8 650 b) When installed with the air outlet directed towards the wall (fig. 5a), it will be necessary to drill an air ducting opening, measuring Ø120 or 150 mm, 6 according to the diameter of the S 2 1 flange F provided. 2 - Fitting the fixing elements a) Insert the rawl plugs provided V 4 mm 7 4 into holes 1 and 2. O L= A08_07 b) Fit the eye bolts O (fig. c) Fix the wall bracket S in hole 2 using the screw V provided (fig. 15 A08_06 S36_05 25 Part 1 - INSTALLATION INSTRUCTIONS 3 - Fitting the hood canopy C to the wall a) Remove the lower grill and the active charcoal filter if present (see paragraph on maintenance). b) Fit the support rod B using the two screws K (3, 5x9, 5) provided (fig. c) Hook the hood canopy C to the eye B K bolts O fixed in holes 1 (fig. d) Adjust the support rod B so that it pushes against the wall (fig. There are two adjustable hooks at the rear of the A08_08 hood, which can be used to adjust its 8 position as follows: - Turn the screws L until the position of screws N O coincides with the lower O access holes. - Turn the screws N to adjust the vertical and horizontal 9 position of the hood. - Lock the screws L to fasten the hood against the wall. - Insert the plugs T provided in the holes giving access to screws N. S36_09 O L N S36_10 T N A08_11 L L N B 10 T 11 4. 3 - Installation of the chimney A No matter which type of installation is being used, any wooden shelves in the area where the hood is to be fitted must first be removed, drilled and later replaced. 16 Part 1 - INSTALLATION INSTRUCTIONS 1 - Drilling the shelves: a) Using the cardboard template provided, and taking hole "B" as a point of reference, drill the shelves along the central axis to allow the passage of the chimney. The chimney must be inserted into the shelves before it is fixed to the hood canopy C (fig. b) When installing the ducting version with the air outlet directed upwards, if the ducting fan unit is positioned below the line of shelves it will be necessary to drill a suitable hole in the top shelf only, to allow the air ducting pipe to pass through (fig. 2 - Direction and position of the ducting fan unit a) The hood is normally supplied with the air outlet directed towards the wall (fig. 3), if it is to be installed with the air outlet directed to the right or left (fig. 4a-b), it will be necessary to change the direction of the ducting fan unit, proceeding as follows: - Unscrew the screws U (fig. 14); - Turn the ducting fan unit 60° to the right or left; - Replace the screws U. [. . . ] Correctly place the connectors under the cover and tighten the two locking screws (fig. 3 - Once electrical connection has been carried out, check that lights, engine and change of speed work 4 - Fit the lower grill and the activated carbon filter (only for filter mode) (see Maintenance). 27a 26 S36_26 27b S07_23 S36_27 19 Part 2 - USE AND MAINTENANCE INSTRUCTIONS 1 - SAFETY WARNINGS It is most important that all the warnings shown in paragraph 3 of the Installation Instructions are strictly observed. Moreover, pay special attention to the following warnings during the use and maintenance of the cooker hood: - The grease filters and charcoal filters should be cleaned or replaced as recommended by the manufacturer or more frequently if the hood is used consistently (over 4 hours per day). - When using a gas hob in connection with the cooker hood never leave the burners of the hob uncovered while the hood is in use or when the pans have been removed. [. . . ]