User manual REX FI45F

[. . . ] INFO INSTALLATION AND INSTRUCTION MANUAL BUILT-IN REFRIGERATOR ER 6424 U-ER 1424 U 2222 680-53 WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. General Safety This appliance is designed to be operated by adults. [. . . ] 5 600 820÷870 550 D100 The appliance is equipped with adjustable support feet (Fig. To adapt the appliance to the height of the installation area, remove the feet, screw on nuts (A) (which you will find in the pack) then refit the feet. Finally, adjust the height and fully tighten the nuts. Fig. 6 A D101 Slide the appliance into the recess, pushing it against the adjacent cabinet wall on the handle side. Fasten the appliance to the worktop or the sides, using the holes (E). Then apply the sealing strip between the refrigerator and the adjacent cabinet (Fig. 7 E The plinth (F) may be set at different depths to a maximum of 55 mm (Fig. Ventilation occurs through the front ventilation grille (G). For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. Air enters through the right side and exits through the left side. Fasten the ventilation grille into position with the two screws. Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 9 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 9 H 20m m D094 5 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 10 8mm Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. PR34 Fig. [. . . ] The frozen food will not be affected if the power cut is of short duration (up to 6-8 hours) and the freezer compartment is full, otherwise, it is recommended that the food should be used within a short time (a temperature increase of the frozen food shortens its safe storage period). Thawing Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation. Small pieces may even be cooked still frozen, directly from the freezer: in this case, cooking will take longer. 9 Ice-cube production This appliance is equipped with one or more trays for the production of ice-cubes. Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. [. . . ]