User manual RICOH FW 870

[. . . ] , I In accordance I for the main switch: with ISO Standard 7001, this machine uses the following-- symbols 0 Q) I means POWER ON. I I For good copy quality, Ricoh recommends Ricoh shall not be responsible for any damage or expense that may result from the use of parts other than genuine Ricoh parts in your Ricoh office product. I Note: Some illustrations may be slightly different from your machine. 1 115 V, 60 HZ, 12A Power Source: Please make sure to connect the power cord to a power source as above. [. . . ]  If you do not want to store the settings, press the Clear Modes key. COPYING 23 USING THE PROGRAM FUNCTION The Program function allows you to store a collection of copy settings as programs 1 to 9 and switch them as needed. programming a Collection of Copy Settings 1 Press the Program key. The indicator on the Program key blinks. The copy counter displays the current program number. 2 Use the and keys to select a program number for which you store copy settings. Each time you make a copy, the copy settings are stored in Program No. You press the Clear/ Stop key, Program No. The indicator on the Program key blinks. 24 COPYING USING THE PROGRAM FUNCTION 4 Specify values for each setting. You can store the following settings with the Program function. For the way to specify values, see the corresponding pages. However, these settings cannot be changed with the Program function. When you specify a paper feeder, the paper type and roll width specified with the Paper Type/Roll Width Entry function (see page 22) are stored.  You can also store the paper type and roll width. 6 If you store settings for another program number, repeat 2 to 5.  The settings are also stored when you press the Program key instead of the Enter key. cOPYING 25 USING THE PROGRAM FUNCTION Recalling Programmed Settings 1 Press the Program key. The indicator on the Program key blinks. The Program key lights and the programmed settings are recalled.  When you press the Program key again, you can cancel the program recall. 26 COPYING COPYING WITH MANUAL FEED When you make a copy with manual feed, you need not replace paper even if the required size or type of paper is not set in the copier. [. . . ] In particular, when the copier is placed near a television or radio, their programs might be hampered by noises. In such a case, take the following actions: • Leave enough space between the copier and the television or radio. • Reorient the television or radio antenna. € Use two outlets separately for the copier and the television or radio. [. . . ]