User manual RICOH MP5163A

[. . . ] To view this manual, use following browsers Microsoft Internet Explorer 4 or later Netscape Communicator 4 or later NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installlation. [. . . ] The system unit must have a free 5. 25-inch bay. The computer system unit must have a free +5V/+12V power terminal. Recommended Tested to be compatible CD-R CD-RW High Speed CD-RW DVD+RW*3 DVD+R Ricoh Ricoh Ricoh Ricoh Ricoh Taiyo Yuden, Mitsui Chemicals, Mitsubishi Chemical, Maxell Mitsubishi Chemical*1 Mitsubishi Chemical Mitsubishi Chemical Hard disk Interface Drive bay Power Recommended discs*2 *1 *2 *3 *4 *5 The disc written using the CD-R/RW drive may not be readable by CD-ROM drives. Multi-read compatible (Random UDF compatible) drives are necessary. Some discs (even recommended media) may fail at the highest writing speed due to a problem on the disc. In this case, please try to write with a lower writing speed, or please use another disc. Ricoh's original phase-change recording material which is field-proven for CD-RW is being used for DVD use. Rewritable DVD+RW/+R have the capacity of 4. 7 GB, the same as DVD-ROM. Recommended when Direct-to-DVD capability is being used. Real-time recording (Pentium 4 1. 4 GHz processor is recommended when Direct-to-DVD capability is used). In addition, a video-capture board for image-capturing must be obtained separately. Multi-read compatible (Random UDF compatible) drives are: q q Drives that can read low reflectivity discs. Drives that support Packet Write. Front Panel Rear panel Front Panel 1. Disc tray This is the tray for the disc. Place the disc on the ejected disc tray, then lightly push the tray (or push the eject button) and the disc will be mounted. Caution Don't use force to pull out or push in the disc tray. This might cause damage to the loading section of the drive. 2. Headphone jack This jack is for connecting headphones or mini-speakers. 3. Volume control This is used to adjust the output volume of the headphone jack. It can't be used to adjust the output volume for the audio output connectors on the rear panel. Caution Turn the volume down before turning on the power. Sudden loud noises can damage your hearing. 4. Busy indicator This indicator lights orange when a disc is mounted into the drive. When the disc is being accessed, it flashes or lights orange. If a disc is not mounted, the indicator does not light even when the power is turned on. When you push a thin, stiff wire into the hole, it presses one of the vanes around the gear, thus rotating the gear for ejecting the tray. [. . . ] Sound Card Connection If the computer has a sound card, the drive can be connected to the sound card with an audio cable. Make sure the connections are oriented so that L corresponds to L and R to R. Refer to the manual for the sound card for detailed information regarding connection. The drive When L, R Sound Card Motherboard Primary or Secondary Back 1. [. . . ]