User manual RICOH MP7040A

[. . . ] NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installlation. [. . . ] System environment This unit can be operated in the system environment explained here. CPU System requirements Memory 100 MHz (or faster) Pentium (for 4x speed, 166MHz or faster recommended) Windows 98/95: 32MB or greator. 4. 0: 32MB or greator (64MB or over recommended) Hard disk with average access time of 19msec or less, and data transfer speed of 1, 200KB/sec or greater. 75MB or more free space. (The free space needed for writing depends on the quantity of data. ) Enhanced-IDE interface (as Primary Slave, Secondary Master, or Slave) 5. 25-inch half height bay required +5V/+12V power socket required Windows 98/95, Windows NT Workstation Ver. 4. 0 (Service Pack 3) or later*1 Ricoh, Kao, Mitsubishi Chamical, Taiyo Yuden, Mitsui Toatsu, TDK or Kodak discs are recommend. MP 7040A Series Harddisk Interface Drive bay Power Sofyware Required OS CD-R, CD-RW discs Occasionally the CD-R and CD-RW discs written by the CD-R/RW drive cannot be read by other CD drives*2. These unreadable discs should be read using the CD-R/RW drive. 4. 0, only usable with Adaptec EASY CD CREATOR. * 2 The disc written using the CD-R/RW drive might not be readable by CDROMs other than Multi-read compatible (Random UDF compatible) CDROMs. Multiread compatible (Random UDF compatible) CD-ROMs are: CD-ROMs that can read low reflectance CD-ROMs that support Packet Write. 2 2. Drive functions and settings 2. 1 Front Panel Disc tray Volume control Headphone jack Name Disc tray Eject button Power/busy indicator Eject button Volume control Headphone jack Power/Busy indicator Function This is the tray for the disc. Place the disc on the ejected disc tray, then lightly push the tray (or push the eject button) and the CD will be loaded. Don't use force to pull out or push in the disc tray. This might cause damage to the loading section of the drive. This is the button used to eject or bring in the disc tray. This is used to adjust the output volume of the headphone jack. It can't be used to adjust the output volume for the audio output connectors on the rear panel. Turn the volume down before turning on the power. Sudden loud noises can damage your hearing. This indicator is not illuminated unless the disk is currently being accessed. This jack is for connecting headphones or mini-speakers. This indicator light shines green when power is on. When the disc tray or disc is being accessed, the light shines or flashes orange. Even when a disc is loaded and a disc is not being accessed, the light shines grean. When a illegal disc is loaded or some hardware trouble occurs, the indicator blinks. 3 MP 7040A Series 2. 2 Rear panel Analog Audio Output Connector Jumper Connector Power connector MP 7040A Series Digital Audio Output Connector IDE Interface Connector Name Power Connector IDE Interface Connector Jumper Connector Analog Audio Output Connector Digital Audio Output Connector Function Connects to the power supply (5- and 12-V DC) of the host computer. [. . . ] Don't use this feature except in an emergency. (2) Poke a fine tipped object into the small hole above the eject button. (3) Grip the disk with your thumb and forefinger and gently pull it straight out. This feature is a last measure to be used only in an emergency. [. . . ]