User manual RIDGID AC1040

[. . . ] Ground Your Tool If your tool is equipped with an approved 3-conductor cord and a 3prong grounding type plug to fit the proper grounding type receptacle. The green conductor in the cord is the grounding wire. Never connect the green wire to a live terminal. Keep Guards In Place In working order, and in proper adjustment and alignment. [. . . ] Always wear eye protection which is marked to comply wtih ANSI Z87. 1. Also, use face or dust mask if cutting operation is dusty, and ear protectors (plugs or muffs) during extended periods of operation. 2 13. Secure Work Use clamps or a vise to hold work when practical. It's safer than using your hand, frees both hands to operate tool. Don't Overreach Keep proper footing and balance at all times. Maintain Tools With Care Keep tools sharp and clean for best and safest performance. Follow instructions for lubricating and changing accessories. Disconnect Tools Before servicing; when changing accessories such as blades, bits, cutters, etc. To Reduce The Risk Of Accidental Starting Make sure switch is in "OFF" position before plugging in. Turn switch "OFF" in the event of a power failure. Use Recommended Accessories Consult the operator's manual for recommended accessories. Follow the instructions that accompany the accessories. The use of improper accessories may cause hazards. 19. Never Stand On Tool Serious injury could occur if the tool is tipped or if the cutting tool is accidentally contacted. Do not store material above or near the tool such that it is necessary to stand on the tool to reach them. Check Damaged Parts Before further use of the tool, a guard or other part that is damaged should be carefully checked to ensure that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced. If power cord is worn or cut, or damaged in any way, have it replaced immediately. Direction Of Feed Feed work into a blade or cutter against the direction of rotation of the blade or cutter only. Don't leave tool until it comes to a complete stop. 3 WARNING: For your own safety, turn switch "OFF" and remove plug from power source outlet before removing insert. [. . . ] Manual furnished with your table saw 4 3. Rotate the dado set or molding head manually, (don't touch it with your fingers, but use a stick of wood) to be sure it clears the insert before connecting the power cord to the electrical outlet in your shop. WARNING: Always rotate the cutter manually with the saw unplugged to assure there is no contact with the saw or insert. Failure to heed this warning can result in serious personal injury. 4. [. . . ]