User manual RL FLO-MASTER 1201KM

[. . . ] AFTER USE release pressure and clean the sprayer. ALWAYS RELEASE pressure in sprayer before servicing. DO NOT alter the sprayer or any components. acids, chlorines and bleach), corrosive, heated or self-heating solutions with this sprayer. [. . . ] To release pressure from the tank, turn the tank upside down, and then squeeze the flow control lever until all the air pressure is gone. If your sprayer has a pressure relief valve, turn yellow knob clockwise until all air pressure is gone. If your sprayer is clogged and the pressure will not release using the flow control, do the following: a. Place a rag over the top of the sprayer and pump. While firmly pushing down on the pump handle, slowly turn counter-clockwise. ALWAYS RELEASE pressure in sprayer before servicing. NEVER leave pressurized sprayer unattended. E. If the chemical is stored in the tank, it can clog the system as it dries and destroy the seals and other components. To prolong its life, clean the sprayer after each use. After using water-based products, rinse thoroughly with soapy water then clean water, being sure to flush out the hose and flow control. After spraying solvent or oilbased products, follow the chemical manufacturers' recommended cleaning procedure, following up with a thorough rinsing and flushing of the sprayer, hose and flow control with soapy water then clean water. To store the sprayer, remove the complete hose assembly (hose w/siphon tube, wand, flow control) from the tank. For proper drainage and drying, lock flow control lever on. Loosen pump assembly, but leave in the tank. Store all components in a clean, dry area. PUMP MAINTENANCE & DISASSEMBLY To keep the pump working smoothly and efficiently, the plunger o-ring needs to be lubricated often by applying grease or petroleum jelly around the outside of the plunger o-ring. · Remove pump assembly from the tank. · Unlock the pump handle and pull it out as far as it will go. · With a flat blade screwdriver, push down on the tabs on each side of the pump. Pull up and the handle and the plunger assembly should come out of the pump cylinder. · To reassemble, insert the plunger assembly into the cylinder and snap the cap back into place. TROUBLESHOOTING Always depressurize the sprayer, remove all chemical solution and clean the sprayer before making repairs. Replacement parts may be purchased at the store where the sprayer was purchased or they can be ordered from our Customer Service Hotline at 1-800-253-4642. [. . . ] ROOT-LOWELL MANUFACTURING CO. 'S LIABILITY IS LIMITED SOLELY TO THE REPAIR OR REPLACEMENT OF THE NON-FUNCTIONING PRODUCT OR PART. EXCLUDES LIABILITY UNDER THIS WARRANTY FOR ANY AND ALL INCIDENTAL AND CONSEQUENTIAL LOSS OR DAMAGE. Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of incidental or consequential damages, so these limitations or exclusions may not apply to you. This warranty gives you specific legal rights and you may have other rights which vary from state to state. [. . . ]