User manual ROBLIN ASTRA 600 DIMENSIONS

[. . . ] Gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. [. . . ] ⷠNever leave high naked flames under the hood when it is in operation. ⷠAdjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. ⷠDeep fat fryers must be continuously monitored during use: overheated oil can burst into flames. ⷠThe hood should not be used by children or persons not instructed in its correct use. mAINTENANCE · Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. ⷠClean and/or replace the Filters after the specified time period. ⷠClean the hood using a damp cloth and a neutral liquid detergent. Draw a vertical line on the supporting wall up to the ceiling, or as high as practical, at the centre of the area in which the hood will be installed. ⷠDraw a horizontal line at 650 mm above the hob for installation without the back panel, or at height H (height of the visible part of the panel) for installation with the back panel. Insert the lower chimney fixing bush 17 in the top of the hood body and rotate it 90° clockwise as far as it will go. ⷠSlightly widen the two sides of the chimney and hook them between the upper chimney section and the wall, making sure that they are properly housed. ⷠSecure the sides of the bottom section to the bushes provided using the 2 screws 12e supplied. ⷠWhen installing the recirculation version, fit the directional grills 8a ­ 8b in their housings so that the directional symbols are at the top and towards the front of the hood. Ensure that they are inserted correctly in the outlet connection piece 15 Switches the lighting system on and off Switches the extractor motor on and off Sets the operating speed of the extractor: 1. Low speed, used for a continuous and silent air change in the presence of light cooking vapour. Medium speed, suitable for most operating conditions given the optimum treated air flow/noise level ratio. Maximum speed, used for eliminating the highest cooking vapour emission, including long periods The filters must be cleaned every two months of operation, or more frequently with heavy usage, and can be washed in a dishwasher. ⷠRemove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. [. . . ] ⷠRemove the filters one at a time by pushing them towards the back of the group and pulling down at the same time. ⷠWash the filters, taking care not to bend them. ⷠWhen refitting the filters, make sure that the handle is visible on the outside. [. . . ]