User manual ROBLIN ATRIUM ASYMETRIQUE

[. . . ] 6 GB Thank you for buying a Roblin product which has been manufactured to the highest quality standards to meet your requirements. We recommend you carefully read this booklet in which you will find instructions for installation, hints for use and maintenance. The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. [. . . ] Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan. Before fitting the chimney to the canopy make the electrical connection as described in the section titled ELECTRICAL. When the electrical connection has been made, test the lights and the fan motor. Remove the metal grease filters and insert the charcoal filter into the base of the motor housing and secure the filter with two metal securing straps item A as illustrated in Fig. Upper chimney stack •Slightly widen the two sides of the upper chimney stack (Fig. 7 - Item 7a) and hook them behind the brackets item 2 making sure that they are well seated. €Secure the sides to the brackets using the 4 screws 12c (2, 9 x 9, 5) supplied. Lower chimney stack •Slightly widen the two sides of the chimney stack (Fig. 7 - Item 7b) and hook them between the upper chimey stack and the wall, making sure that they are well seated. €Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. Press the ‘+’ button (while the motor and lights are switched ‘OFF’) until the five LED lights will flash twice to indicate confirmation that the cooker hood is in the recycling mode. Reverting to the extraction mode (The cooker hood is ducted to the outside). Press the ‘+’ button (while the motor and lights are switched ‘OFF’) until the five LED lights will flash once to indicate confirmation that the cooker hood is in the extraction mode. GB B - BASIC INSTRUCTIONS Lighting Press LED button 1 to switch ‘ON’ the lights and the LED will illuminate to confirm the lights are switched ‘ON’. Motor Press LED button 2 to switch ‘ON’ the fan motor (and adjust the speed of the fan motor by pressing the LED button ‘+’ and ‘-‘) and the LED lights 2, 3 and 4 will illuminate. The fan speed will be increased if constant pressure is kept on the (+) button. LED 2 : Minimum speed - cooking with one pan or simmering LED 2 & 3 : Medium speed - normal cooking with up to 4 pans LED 2, 3 & 4 : Maximum speed - frying and cooking foods with strong odours Press LED button 5 to obtain the boost position for maximum effect and the LED will illuminate to confirm fan is switched ‘ON’. C - COMPLEMENTARY INSTRUCTIONS • Boost speed : To obtain the best performance it is advisable to switch ‘ON’ the cooker hood a few minutes (in the boost setting) before you start cooking. To program the complementary function, proceed as follows: - Press LED button 2 to switch ‘ON’ the fan motor and adjust the speed of the fan by pressing the LED button ‘+’ and ‘-‘. You should keep applying pressure to the ‘+’ and ‘-‘ button until the required speed is selected. - Press LED button 5 (boost speed) to switch ‘ON’ the fan motor in the boost setting. press LED button 5 to switch ‘OFF’ the boost setting immediately. [. . . ] If lamp failure has occurred then it should be replaced with identical replacement. Do not replace with any other type of lamp and do not fit a lamp with a higher rating. 7 GUARANTEE AND AFTER SALES SERVICE • In the event of any malfunction or anomaly, notify your fitter who will have to check the appliance and its connection. • Replace the metal grease filters. [. . . ]