User manual ROBLIN BOSTON 1200 MURALE DIMENSIONS

[. . . ] 3 - Connect the cooker hood to the mains via a bipolar switch which has 3mm clearance between the contacts. 5 - When installed, the hood must be positioned at least 65 cm above the hotplate. 7 - Never leave frying pans unattended during use as overheated fat and oil may catch fire. 8 - Before carrying out any kind of maintenance or cleaning, disconnect the hood from the mains supply. [. . . ] 8 - Before carrying out any kind of maintenance or cleaning, disconnect the hood from the mains supply. 9 - If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then this must be of the room sealed or balanced flue type. If other types of flue or appliance are fitted, ensure that there is an adequate supply of air into the room. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. 1 - Make a rectangular opening in the base of the overhead cupboard or hood, leaving a minimum of 13 mm from the outer edges according to the dimensions indicated in the table. 2 - Drill a hole into the upper side of the cabinet in accordance with the dimensions of the duct used for both the evacuation and recirculation mode. 3 - Dismantle the ducting support (version with grill or version with filters), pulling the two pommels A (fig. 1) simultaneously: a) Fixing frame with screws: Fix the fitted group to the hood or cupboard, using the self-threading screws (No. B) Rapid fixing with side supports: The device B is set up to deal with a panel thickness of from 15 mm to 30 mm. Insert the group into the opening until the two devices B connect. 2 - Replacement The metal filters are easily removed, one at a time, applying a slight pressure towards the rear of the hood while pulling downwards (fig. ATTENTION: There could be a possible fire hazard if the filters are not replaced according to these instructions. 1 - This filter cannot be washed and should be replaced every two months. If the filter is provid ed with a saturation indicator, replace when the violet color of the dots which are visible from the outside is spread over the whole surface of the filter. B) After having taken off the ducting grill, remove the filter stops (1). 1 - Cleaning The metal grease filter should be cleaned every two months with normal usage and can be cleaned in a dishwasher or by hand using mild detergent or liquid soap. ATTENTION: There could be a possible fire hazard if the filters are not replaced according to these instructions. 1 - Functioning In the recycling mode the charcoal filters absorb smell and odours. The charcoal filter cannot be washed or regenerated and should be replaced every 2 months or more frequently if the hood is used consistently. 1 - This is provided by two 40 W lamps or by two 20 W haolgen lamps. [. . . ] 1 - Functioning In the recycling mode the charcoal filters absorb smell and odours. The charcoal filter cannot be washed or regenerated and should be replaced every 2 months or more frequently if the hood is used consistently. 1 - This is provided by two 40 W lamps or by two 20 W haolgen lamps. If the lamps do not work, open the suction grille and check that they are properly fitted. [. . . ]