User manual ROBLIN CREATIX BK - 5045001

[. . . ] 72 3 3 RECOMMENDATIONS AND SUGGESTIONS The Instructions for Use apply to several versions of this appliance. Accordingly, you may find descriptions of individual features that do not apply to your specific appliance. € The manufacturer will not be held liable for any damages resulting from incorrect or improper installation. € The minimum safety distance between the cooker top and the extractor hood is 650 mm (some models can be installed at a lower height, please refer to the paragraphs on working dimensions and installation). [. . . ] € From the inside of the hood body, turn screws Vr to level the hood body itself. 11a Vr 12a Connections DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. € To install a ø 120 mm air exhaust connection, insert the reducer flange 9 on the hood body outlet. € Fix the pipe in position using sufficient pipe clamps (not supplied). • Remove possible charcoal filters. ø 150 9 ø 120 EN 8 8 RECYCLING VERSION AIR OUTLET To install the hood in recycling version, the optional charcoal filter kit must be purchased. • Remove the chimney angle bracket. € Screw the filter cover onto the air outlet, using four screws 12c (2. € Fix the air outlet grid 8 on the recirculation air outlet using the 2 screws 12d (2, 9 x 9, 5) provided. 16 8 12d 12c Fitting the Lighting Unit • • • • • Insert the Lighting unit cable into the opening. Inside the hood canopy there is a wiring box for connection of the lighting unit. € Open the box and connect the wires to the terminal inside it, checking that the colours are combined properly. € Close the wiring box, replace the grease filters and close the doors. 12r EN 9 9 ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. € Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan. Chimney assembly Upper exhaust Chimney • Slightly widen the two sides of the upper chimney and hook them behind the brackets 7. 1, making sure that they are well seated. € Secure the sides to the brackets using the 4 screws 12c (2, 9 x 9, 5) supplied. Lower exhaust Chimney • Slightly widen the two sides of the chimney and hook them between the upper chimney and the wall, making sure that they are well seated. € Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. This speed is timed to run for 10 minutes. At the end of this time the system will automatically return to the speed set before. [. . . ] € Do not place the remote control near to heat sources. € Used batteries must be disposed of in the proper manner. Metal grease filters These can also be washed in the dishwasher, and need to be cleaned whenever the 24H Led flashes or at least once every 2 months use, or more frequently if use is particularly intensive. Resetting the alarm signal • Turn the Lights and the Suction Motor off. [. . . ]