User manual ROBLIN CUBIX CENTRALE 600

[. . . ] Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. The hood should not be used by children or persons not instructed in its correct use. [. . . ] Fix the pipe in position using sufficient pipe clamps (not supplied). Attach the adhesive Novastik gasket 13 to the air outlet connection 15 and fix this to the upper frame using the 2 knobs 24. Fix the air outlet connection extension piece 14 to the air outlet connection 15. Place the air outlet connection tube 29 between the two air outlets. Place the upper chimney section and fix the upper part to the the Fixing Part of the Upper Chimney using the 4 screws 12c (2, 9 x 9, 5) provided. recirculation version · It is necessary to make sure that the air outlet connection 15 is placed correctly so that the air outlet grid in it corresponds to that of the chimney. If the grids of the two parts are not corresponding to each other, it will be necessary to remove the chimney and to adjust the position of the air outlet connection 15, and at last to assembly the parts again by following the earlier indications. Before fixing the hood body to the frame: · From below, use the 4 screws 12f (M6 x 10) provided to fix the hood body to the frame. Connect the Hood to the mains power supply, inserting a twopole cut-out switch with contact aperture of at least 3 mm along the line. Pull the Comfort Panel to open it, ensure that the supply cable connector is properly inserted into the Suction device socket · The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button. When pressed for about 2 seconds the motor is switched off. It allows a suction level of 100 m3/h with a noise level of just 28dB(A). Can be enabled at any speed, even with the hood turned off. Suitable to complete elimination of any residual smells. Can be enabled at any speed and is disabled by pressing the button briefly. The function becomes active when the button is pushed for about 2 seconds. After 10 minutes of functioning it turns off automatically. This function can be interrupted by means of pressing any of the buttons. [. . . ] Press button T3 for at least 3 seconds, until the leds start to flash. Fit the new filter by hooking it into its seating · Remove the 2 screws fixing the Lighting support, and pull it out of from the Hood. Replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes. [. . . ]