User manual ROBLIN LINEAR 900 MURALE DIMENSIONS

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual ROBLIN LINEAR 900 MURALE. We hope that this ROBLIN LINEAR 900 MURALE user guide will be useful to you.

Lastmanuals help download the user guide ROBLIN LINEAR 900 MURALE.


Mode d'emploi ROBLIN LINEAR 900 MURALE
Download
Manual abstract: user guide ROBLIN LINEAR 900 MURALEDIMENSIONS

Detailed instructions for use are in the User's Guide.

[. . . ] ⷠThe ducting used must be made from fire retardant materials and the correct diameter must be used, as incorrect sized ducting will affect the performance of this cooker hood. ⷠWhen the cooker hood is used in conjunction with other appliances supplied with energy other than electricity, the negative pressure in the room must not exceed 0. 04 mbar to prevent the fumes from combustion being drawn back into the room. ⷠThe appliance is for domestic use only and should not be operated by children or people who are infirm without supervision. [. . . ] The ducting used must be 150 mm (6 ins), rigid circular pipe and must be manufactured from fire retardant material, produced to BS. Wherever possible utilise rigid circular pipe which has a smooth interior, rather than the expanding concertina type ducting. Maximum length of ducting run : 4 metres with 1 x 90° bend. The above assumes our 150 mm (6 ins) ducting is being installed. And ducting kits are optional accessories and have to be ordered, they are not automatically supplied with the chimney hood. Fit the noise-reduction tubes over the round outlets on top of the canopy while pressing down until they snap into position and then fit the non-return backflow flaps onto the top of the noise-reduction tubes as illustrated Fig. Connect the ducting 150mm ( 6ins) and secure the connections with appropriate clamping rings or adhesive tape. Before fitting the chimneys to the canopy make the electrical connections as described in the section titled ELECTRICAL. When the electrical connection has been made , test the lights and the fans motors. Connect the ducting 200 mm ( 8ins) onto the round outlets on the top of the canopy and onto the round inlet of the motors at a distance and secure the connections with appropriate clamping rings or adhesive tape. Connect the earth connections onto the terminals marked with the earth symbol and clamp the connectors onto the motors housing as illustrated Fig. While the 5 minutes timer is running, the indication of saturation of the filters is switched `OFF'. If a pre-set stop for the hood is switched `ON' and the 5 minutes timer is still running, the boost speed will be switched `OFF' together with the pre-set stop for the hood after the count down of 5, 10 or 15 minutes. It is available to stop the boost speed before the count down of the preset stop of the hood by pressing the led button 5. ⷠPre-set stop for the hood : This function allows you to program the cooker hood to automatically stop cooking after a pre-set period. The lights and the fan motor should be switched `OFF' to set the timer. ⷠIndication of saturation of the metal grease filters : After 200 hours use, one quick flash of the LED 1 will indicate that you must clean the metal grease filters. To reset the 200 hours timer back to zero requires the motor and lights must be switched `OFF'; then and proceed as follows: Press the LED button `+' for 3 to 4 seconds and the LED lights 1, 2, 3, 4 and 5 will flash to confirm the programme has been reset to zero. Indication of saturation of the active charcoal filter : After 400 hours use, two quick flash of the LED 1 will indicate that you must replace the active charcoal filter and clean the metal grease filters. Two flashes of the LED lights 1, 2, 3, 4 and 5 = function is switched `ON'. To use the cooker hood with a remote control re-programme the hood as follows: Press the LED button (Lighting) `1' while the motor and lights are switched `OFF', until the LED lights 1 will flash to confirm the programme has been activated : One flash of the LED lights 1 = function is switched `OFF'. Two flashes of the LED lights 1 = function is switched `ON'. [. . . ] When this crossed-out wheeled bin symbol is attached to a product it means the product is covered by the European directive 2002/96/EC. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. please inform yourself about the local separate collection system for electrical and electronic product. Please act according to your local rules and do not dispose of your old products with your normal household waste. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE ROBLIN LINEAR 900 MURALE

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual ROBLIN LINEAR 900 MURALE will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag