User manual ROBLIN MISTRAL 800

[. . . ] It is a possible fire risk if the hood is not sited as recommended. To ensure the best results, the cooking fumes should be able to rise naturally towards the inlet grilles on the underside of the cooker hood and the cooker hood should be positioned away from doors and windows, which will create turbulence. If the room where the hood is to be used contains a fuel-burning appliance such as a central heating boiler then its flue must be of the room sealed or balanced flue type. [. . . ] g)Attach the appliance on the wall using stainless-steel screws and dowels. H)Put the cover of the appliance bock in place and screw the 2 hex domed nuts. Comply with this diameter and number of bends to the minimum, so as to ensure good air flow. K)Connect up the power cord of the appliance for Outside Wall Aspiration on the 6 - way connectorby observing figure n° 3. To obtain the best performance we recommend you to switch `ON' the cooker hood a few minutes (in the boost setting) before you start cooking and you should leave it running for approximately 15 minutes after finishing. Do not leave frying pans unattended during use as over-heated fat and oil might catch fire. Do not leave naked flames under this cooker hood. switch `OFF' the electric and gas before removing pots and pans. Ensure heating areas on your hotplate are covered with pots and pans when using the hotplate Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean; a build up of fat or grease may cause a fire hazard. casing · Wipe the cooker hood frequently with a clean cloth, which has been immersed in warm water containing a mild detergent and wrung out. Never use excessive amounts of water when cleaning particularly around the control panel. Always wear protective gloves when cleaning the cooker hood. Metal Grease Filters : The metal grease filters absorb grease and dust during cooking in order to keep clean the cooker hood inside. The grease filters should be cleaned once a month or more frequently if the hood is used for more than 3 hours per day. active Charcoal Filter : The charcoal filter cannot be cleaned. The filter should be replaced at least every three months or more frequently if the hood is used for more than three hours per day. Press against the two retaining clips, which hold the charcoal filter in place and this will allow the filter to drop down and be removed. [. . . ] Any permanent electrical installation must comply with the latest I. For your own safety this should be undertaken by a qualified electrician e. Your local Electricity Board, or a contractor who is on the roll of the National Inspection Council for Electrical Installation Contracting (NICEIC). [. . . ]