User manual ROBLIN UNIVERS/3

[. . . ] Gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE • The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. € Never use the hood for purposes other than for which it has been designed. [. . . ] € Make sure that the outlet of the extension pieces 14. 1 is horizontally and vertically aligned with the chimney outlets. € Connect the air outlet connection 15 to the hood body outlet using either a flexible or rigid pipe ø 150 mm, the choice of which is left to the installer. € Ensure that the activated charcoal filters have been inserted. 1 15 ø 150 EN 1 14 ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. € Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan. Flue assembly Upper exhaust flue • Slightly widen the two sides of the upper flue and hook them behind the brackets 7. 1, making sure that they are well seated. € Secure the sides to the brackets by using the 4 screws 12c (2, 9 x 9, 5) supplied. € Make sure that the outlet of the extensions pieces is aligned with the chimney outlets. Lower exhaust flue • Slightly widen the two sides of the flue and hook them between the upper flue and the wall, making sure that they are well seated. € Fix the lower part laterally to the hood body by using the 2 screws 12c (2, 9 x 9, 5) supplied. 2 12c EN 1 15 USE A B C D E F G H Control board Key A B C D Function Display Switches the extractor motor on and off at the Indicates the selected speed. Latest selected speed Decreases the suction speed. The spot down on the right side the intensive speed from any previously se- flashes once a second. The intensive speed can be activated even when the motor is OFF. this speed has been timed at 10 minutes. After that time the system activates automatically the latest selected speed. This function is suitable for cooking conditions when vapours and smells are of the utmost emission. By pressing this key it is possible to set up the motor to a suction speed at 100 m3/h lasting 10 minutes every hour. After this the motor switches off automatically. When the filter saturation is going on it is possible to reset the alarm by pressing this key for about 3 seconds. [. . . ] € Press the E-key until the display is unlit. Replacing of the filter • Remove the metal grease filters. € Remove the saturated charcoal filter by releasing the fixing hooks • Fit the new filter and fasten it in its correct position. € Put the metal grease filters in their seats. [. . . ]