User manual ROCKTRON TOL100

[. . . ] This unit is designed to operate between 32° F and 104° F (0° C and 40° C). This unit may not function properly under extreme temperatures. Copyright © 2000 GHS Corporation All Rights Reserved. 1 1 2 3 4 5 6 7 8 9 10 11 12 13 INPUT JACKS - LOW AND HIGH Connect the output of your guitar to one of the 1/4"input jacks with a shielded guitar cable. Select LOW for normal, or HIGH for extra gain. Plugging into the LOW input will attenuate your guitar's signal cooling down a "hot" guitar. [. . . ] Experiment with these and adjust to your tastes. PREAMP GAIN - DRIVE Turning this knob clockwise determines the amount of gain (or distortion) added to the signal. PREAMP GAIN - CLEAN This knob controls the Clean Channel Level. CH SELECT - Button & DRIVE LED Channel Select button - allows you to select between the DRIVE channel or the CLEAN channel. The DRIVE LED is ON (or lit) when the DRIVE channel is active. MASTER - Volume Control The MASTER volume control adjusts the overall sound level. REVERB control Adjusts the amount of reverb added to your guitar's signal. Turn the knob clockwise to increase the effect. CHORUS button and ON/RATE LED Push in to activate the CHORUS. The ON/RATE LED is illuminated when CHORUS is ON and flashes to indicate RATE speed. RATE control This controls the delay time for the CHORUS effect. You may also run the signal out to a stereo power amp with volume controls and from there into two 4x12s, a stereo 4x12 or a stereo 2x12 cabinet. The line output is not controlled by the master volume control. * Rocktron Rampage single (RFS1) and double (RFS2) footswitches are available and sold separately. 2 3 4 5 Built-in Chromatic Tuner Functions 4 2 1 1 3 On/Off button Press this button to engage the tuner function. When tuner is on the LED lights will be on depending on the note you play. To match the pitch of any instrument or audio source (like an old piano or tape player) press the auto calibration button while playing the note on the instrument. (Note: you might have to first tune one string on the guitar by ear to match the actual note if the piano is out of standard tuning or if tape player you are playing along with runs slower or faster than normal). Once you have one note on the guitar tuned to the source - simply play that note on the guitar - while the note is "ringing" press the Auto Calibration button. The tuning pitch of the tuner will automatically be shifted the match the pitch of the audio source. Release the button and tune the remaining strings as normal with the tuner. The tuner at this point has automatically adjusted the tuning range to match that pitch. To reset the tuner to standard 440Hz pitch you turn the tuner off and then back on again. [. . . ] NOTE LED display: These LEDs show the note being tuned. The LED under the note being tuned will be lit. TUNE LED display This series of 5 LEDs shows you if the note being played (tuned) is either sharp or flat. 2 3 4 To Tune: 1) Turn on tuner function 2) Play a note on your guitar. The tuner automatically senses the note being played and will show you the note which is the closest to the one being played by lighting the appropriate LED in the NOTE LED display. [. . . ]