User manual ROLAND KF

[. . . ] Owner's Manual 201a Before using this unit, carefully read the sections entitled: "USING THE UNIT SAFELY" (p. These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner's manual should be read in its entirety. The manual should be saved and kept on hand as a convenient reference. 202 Copyright © 2002 ROLAND CORPORATION All rights reserved. [. . . ] Press the [ (Reset)] button. Recording will start at the beginning of the song. If you want to record from a point other than the beginning, use the [ (Bwd)] and [ (Fwd)] buttons to select another measure to begin. Punch-in Recording (p. 119) You can re-record only a specified passage as you listen to a recorded performance. Immediately after the power is turned on, Replace Recording is selected. 5. Press the [ light up. (Rec)] button and watch the indicator is The KF-7 is put in recording standby. Chapter 6 6. Press the [ (Play/Stop)] button. A two-bar count-in sounds, then recording starts. * You cannot use the performance pads when recording with the 16-track sequencer. 7. Press the [ Recording stops. (Play/Stop)] button. When one part is recorded, continue by selecting and recording another part. Continue layering parts to finish recording the song. You only need to follow the procedure described in "Step 1 ­ Prepare for Recording" when you're recording the first Part. For the second Part and after, you can skip step 1 and proceed from "Step 2 Start Recording. " * Any performance that has been recorded is deleted when the power to the KF-7 is turned off. It is a good idea to save song data to a floppy disk or user memory. For more information, refer to "Saving Songs" (p. 101). 116 Chapter 6 Creating and Editing Songs Changing the Recording Method 1. Press the [Menu] button. The Menu screen appears. fig. d-menu1. eps_50 Recording While Erasing the Previous Recording (Replace Recording) The recording process where previous material is erased as new material is recorded is called "replace recording. " This setting is in effect when you turn on the power. 1. 117), select <Replace>. Touch <Exit> to return to the Menu screen. The KF-7 is set to the replace recording mode. Record the performance using the procedures described in Chapter 4 (p. 90), "Multitrack Recording with 16 Parts (16-Track Sequencer)" (p. Touch <Rec Mode>. A "Rec Mode screen" like the following appears. fig. d-recmode. eps_50 Layering a Recording Over Previously Recorded Sounds (Mix Recording) You can record a performance layered over a previously recorded performance. This method is called "Mix Recording. " 1. 117), select <Mix>. Touch <Exit> to return to the Menu screen. [. . . ] DE PANAMA TEL: 315-0101 HUNGARY Roland East Europe Ltd. Warehouse Area `DEPO' Pf. 83 H-2046 Torokbalint, HUNGARY TEL: (23) 511011 INDONESIA PT Citra IntiRama J1. 15J-150 Jakarta Pusat INDONESIA TEL: (021) 6324170 CYPRUS Radex Sound Equipment Ltd. 17, Diagorou Street, Nicosia, CYPRUS TEL: (022) 66-9426 CHILE Comercial Fancy II S. A. [. . . ]