User manual ROLAND ME-30

[. . . ] No part of this publication may be reproduced in any form without the written permission of BOSS CORPORATION. All product names mentioned in this document are trademarks or registered trademarks of their respective owners. Enclosed in square brackets [ ] [WRITE] WRITE button Indicates information that you should be aware of when using the ME-30. Technology that simulates existing physical structures, materials, and the like using different, virtual means is called "modeling technology. [. . . ] When playback ends, the recorded data is deleted. When you call up patches or EZ Tones, an effect's parameters may not reflect the actual position of the control knobs. You can set how the parameters behave when the control knobs are moved in this state. Control operation The value changes immediately as the knob is turned (factory setting). The value changes once the knob is turned past the position corresponding to the currently set value. E-15)) to the values set when the unit was shipped from the factory. Never turn off the power while Factory Reset is in progress. However, extended use and certain operating environments can result in the pedal going out of adjustment. If you encounter problems such as the expression pedal's ON/OFF switch not functioning or the volume pedal not fully cutting off the sound, you can use the following procedure to readjust the pedal. The display shows "Pd, " then "Up. Move the heel of the expression pedal all the way Down, then release the pedal and press [WRITE]. 5 hours continuous use (These figures will vary depending on the actual conditions of use. Used for instructions intended to alert the user to the risk of death or severe injury should the unit be used improperly. Used for instructions intended to alert the user to the risk of injury or material damage should the unit be used improperly. * Material damage refers to damage or other adverse effects caused with respect to the home and all its furnishings, as well to domestic animals or pets. the symbol alerts the user to important instructions or warnings. The specific meaning of the symbol is determined by the design contained within the triangle. In the case of the symbol at left, it is used for general cautions, warnings, or alerts to danger. The symbol alerts the user to items that must never be carried out (are forbidden). The specific thing that must not be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the unit must never be disassembled. The symbol alerts the user to things that must be carried out. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ­ Reorient or relocate the receiving antenna. [. . . ]