User manual ROLAND MG-10

[. . . ] Copyright © 2011 ROLAND CORPORATION All rights reserved. No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. Roland is a registered trademark of Roland Corporation in the United States and/or other countries. USING THE UNIT SAFETY About WARNING and CAUTION Notices About the Symbols The symbol alerts the user to important instructions or warnings. The specific meaning of the symbol is determined by the design contained within the triangle. In the case of the symbol at left, it is used for general cautions, warnings, or alerts to danger. [. . . ] If this chapter cannot help you solve a problem, please refer to the support section of our website. If the problem is not resolved, refer to the contact information listed at the end of this document. Roland website: http://www. roland. com/ Driver Installation Problem Installer does not start Confirmation Are you attempting to install from a networked CD-ROM drive?Are you logged on with a user account that does not have administrator privileges?Cannot install Is the "Driver Signing Options" setting set to [Block]?(Windows XP) Are other programs or resident programs (such as antivirus programs) running?Warning or error appears during installation (Windows) In the "Device Manager, " do you see "Other device, " "Unknown device, " or a device for which "?, " "!, " or "x" is displayed?Is your computer running on battery power?Installer does not exit Other than a mouse and keyboard, are any USB devices connected?Is the MG-10 connected to a USB hub that is connected to a power supply?"Found New Hardware Wizard" appears again after driver was installed (Windows XP) Resolution You cannot install from a networked CD-ROM drive. Is the MG-10's USB indicator off? Is the MG-10's device name displayed? Cannot select or use MG-10 device Did the computer enter standby (suspend) mode, hibernate mode, or sleep mode while the MG-10 was connected?Did you disconnect and reconnect the USB cable while using the DUOCAPTURE? Was the MG-10 connected to the computer while the computer was starting up?Cannot change driver settings (Windows 7) Is the monitoring function of Windows turned on? 18 Troubleshooting Problem Confirmation Is the driver installed?Are the software's input device and output device configured?Select the MG-10 as the input and output device (p. Make sure that the MG-10 is connected to the computer correctly. If the problem is not resolved, reinstall the driver (p. Exit all programs that are using the MG-10, disconnect the MG-10's USB cable, and then reconnect it. If the problem is not resolved, reinstall the driver (p. Exit all programs that are using the MG-10, disconnect the MG-10's USB cable, and then reconnect it. If the problem is not resolved, restart the computer. [. . . ] Increase the buffer size if audio drops out. After adjusting the buffer size, make sure to restart all programs that are using the MG-10. If using software that has an "audio device test" function, run the test function. Specifies the minimum buffer size that can be set when using ASIO-compatible software. 1 Audio Buffer Size 2 ASIO Buffer Size Depending on the software you are using, the buffer size displayed here may differ from the actual buffer size. [. . . ]