User manual ROLAND MRM-500

[. . . ] ⷠSkin damage may result if the alkaline liquid from a battery comes into contact with your skin or clothing. If such contact occurs, use plenty of clean water to wash off the affected areas immediately. Doing so may cause the battery to leak, become excessively hot, or burst. [. . . ] Doing so may cause the battery to leak, become excessively hot, or burst. If you notice an unusual smell, this indicates a risk that the electrolyte may ignite; immediately move the battery away from any fire or source of ignition. Before connecting this unit to other devices, turn off the power to all units. This will help prevent malfunctions and/or damage to speakers or other devices. Noise may be produced if wireless communications devices, such as cell phones, are operated in the vicinity of this unit. Such noise could occur when receiving or initiating a call, or while conversing. Should you experience such problems, you should relocate such wireless devices so they are at a greater distance from this unit, or switch them off. Before using this unit, make sure to read the instructions below, and the Owner's Manual. Try to prevent cords and cables from becoming entangled. ⷠIf the battery runs down, the volume may decrease or the audio quality may be impaired. If this occurs, replace the battery with a new one. ⷠIf liquid should leak from the battery, use a soft cloth to carefully wipe clean the battery compartment, then install a new battery. Keep the included screws and the screw adaptor in a safe place out of children's reach, so there is no chance of them being swallowed accidentally. For everyday cleaning wipe the unit with a soft, dry cloth or one that has been slightly dampened with water. To remove stubborn dirt, use a cloth impregnated with a mild, non-abrasive detergent. Afterwards, be sure to wipe the unit thoroughly with a soft, dry cloth. Never use benzine, thinners, alcohol or solvents of any kind, to avoid the possibility of discoloration and/or deformation. When connecting / disconnecting all cables, grasp the connector itself--never pull on the cable. [. . . ] This way you will avoid causing shorts, or damage to the cable's internal elements. Also, do not grasp the cord and pull on it to pick up the microphone. One-point stereo microphone that allows stereo capture of the sound in the direction you aim the microphone · electret condenser design for high audio quality · Two-way power; use plug-in power (takes priority) or an LR44 battery · compact and light-weight for excellent portability; ideal for field recording · Large windscreen included for good rejection of wind noise · * To prevent malfunction and/or damage to speakers or other devices, always turn down the volume, and turn off the power on all devices before making any connections. [. . . ]