User manual ROLAND MZ-2

[. . . ] Flip the arms over and set them in a level position. * Position the arms carefully so as not to allow your hands or fingers to be pinched. Pull the knobs out towards you and set the inner struts to the desired height. Check the height setting numbers marked on the inner struts to make sure that both the left and right legs are set to the same height. [. . . ] * Of the numbers for setting the strut height, use only the numbers from 1 through 12. Setting the height at 13 is not recommended, as this may make the stand unstable. * Take care not to let your hands or fingers get caught and pinched in the notches for the height setting numbers. You can adjust the degree to which the struts open by attaching or removing the angle adapters. * Attach the angle adapters on the inner sides of the strut hinges to prevent from losing them (refer to Fig. Angle Adapter * When removing the angle adapters, be sure to remove them from both struts. Never use the stand with the adapter removed from only one side, as this will cause the keyboard to lean dangerously to one side. Set the keyboard so that the center of the keyboard is aligned with the midpoint of the stand. Adjust the strut height and angle so that the stand is the appropriate width for the keyboard and that any rubber feet on the underside of the keyboard are not resting directly on top of the arms. The symbol alerts the user to items that must never be carried out (are forbidden). The specific thing that must not be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the unit must never be disassembled. The symbol alerts the user to things that must be carried out. The specific thing that must be done is indicated by the design contained within the circle. In the case of the symbol at left, it means that the powercord plug must be unplugged from the outlet. Before using this unit, make sure to read the instructions below, and the Owner's Manual. Do not open or perform any internal modifications on the unit. (The only exception would be where this manual provides specific instructions which should be followed in order to put in place user-installable options; see p. [. . . ] (The only exception would be where this manual provides specific instructions which should be followed in order to put in place user-installable options; see p. Should you remove leg securing screws, angle adapters, and angle adapter screws, keep them in a safe place out of children's reach, so there is no chance of them being swallowed accidentally. Do not attempt to repair the unit, or replace parts within it (except when this manual provides specific instructions directing you to do so). In addition to the items listed under "USING THE UNIT SAFELY" on this page, please read and observe the following: Make sure you always have the unit placed so it is level and sure to remain stable. [. . . ]