User manual ROLAND SR-JV80-19

[. . . ] Then in the "USB Storage screen, " select "Internal" and the internal memory of the V-Synth will appear on your computer as a drive named "SR-JV80-19. " On your computer, copy all of the backup data from the drive (e. g. , hard disk) of your computer into the "SR-JV80-19" drive. After copying the data, operate your computer as described in "Disconnecting the USB connection" (p. 92) of the owner's "Closing the USB storage screer" and manual, and then disconnect the USB cable from the V-Synth. At this point, the backup data has not been loaded into the work area of the V-Synth, so you will be unable to check whether the process has been performed correctly. [. . . ] At this point, the backup data has not been loaded into the work area of the V-Synth, so you will be unable to check whether the process has been performed correctly. Power-off the V-Synth, turn it back on, and use Patch mode etc. to verify that the backup data is loaded correctly. Updating the system Required items · · · * PC USB CABLE UPDATE CD-ROM (#17041297) In order to perform this procedure, the OS of your computer must be Windows XP/2000/Me. 7. * Don't power off on the updating and programs or datas are broken. On the front panel, hold down PATCH PALETTE [NUMBER][1], and power-on the V-Synth. Continue pressing NUMBER [1] until "Program Updater" is displayed. Press the front panel PATCH PALETTE [NUMBER][2] button. The display will indicate "Update by USB Mass Storage. " Use a USB cable to connect the V-Synth and your computer. 9. Preparations for testing · If you will be writing the USB serial number in the [22: USB Test] item, copy the entire "Usb Id Set" folder into the hard disk of your computer, and start up the executable file (UsbIdSet. ext) found within this folder. as follows. MA-10D etc. * fig. connect Perform the update procedure from the beginning, paying careful attention to the above points. · Please exchange the main board Assy when you still can not update correctly. INPUT LR COAXIAL IN OPTICAL IN COAXIAL OUT OPTICAL OUT Test mode Test items PHONES LR MAIN OUT LR DIR OUT LR INPUT IN OUT COAXIAL IN OUT OPTICAL 0: Test Mode Top page (Identifying the version number) 1: Shock test 2: Beep Check 3: Memory Test 4: MIDI Test 5: Sound Test 6: LCD Test 7: Encoder Test 8: A/D Test1 (Bender & Modulation) 9: A/D Test2 (Volume) 10: A/D Test3 (After Touch) 11: A/D Test4 (HOLD, CTL1, CTL2) 12: Touch Panel Calibration 13: Touch panel A/D check 14: XY-PAD Calibration 15: XY-PAD A/D check 16: PC-CARD Test 17: D-Beam Adjustment 18: D-Beam Check 19: Switch & LED Test 20: Keyboard Test 21: Noise Check 22: USB Test · · · · · Button operations Entering Test mode While holding down the three buttons [-OCT] + [+OCT] + [8], turn on the power. Continue holding down the buttons until you hear the beep. The top screen of test mode will then appear. In the top page, press [ ] to begin from test item 1: Shock test. For test items 8~5 and 7~9 the next test item will begin automatically when each test completes successfully. The top page displays a list of the test items. [. . . ] In the top page, press [ ] to begin from test item 1: Shock test. For test items 8~5 and 7~9 the next test item will begin automatically when each test completes successfully. The top page displays a list of the test items. [. . . ]