User manual ROLLEI 35 SE

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Shielded cables and I/O cords must be used for this equipment to comply with the relevant FCC regulations. Changes or modifications not expressly approved in writing by ROLLEI Acoustics may void the user's authority to operate this equipment. [. . . ] 2d Color Code: If you use the transmitter in a multichannel system you can remove the black plastic ring and replace it with a colored ring from the optional Color Coding kit to identify You can use the PT 80 bodypack transmitter with both dynamic microphones and condenser microphones operating on a supply voltage of approx. The HT 80 can be switched to a maximum of 15 different carrier frequencies depending on local frequency allocations. 3b MIC: Mutes the audio signal (position "0") while power and carrier frequency remain ON. Thus, no noise will become audible if you mute the microphone even if the SQUELCH control (1c) on the receiver is set to minimum. LED constantly lighting brightly: batteries will be dead in about 90 minutes. lED illuminating brightly: audio input is overloaded. 3d Audio Input: 3-pin mini XLR connector with both mic and line level pins that automatically match the connector pinout of the microphone or optional MKG/L guitar cable. 3e Color Code : If you use the transmitter within a multichannel system, you may remove the black plastic platelet and replace it with a colored platelet included in the optional Color Coding Kit to identify each channel by a different color. GAIN: This rotary pot allows you to match the microphone or instrument level to the transmitter's audio section. Security Cover: Protects the POWER and MIC switches from being actuated unintentionally. On the same set of frequencies as your original equipment, be sure to state the designation of your original Frequency Set (1k/1l, 2i, 3k/3l) and the serial number of the original device. check that the batteries align with the polarity marks. The transmitter will not function with the batteries inserted incorrectly Important: Do not try to insert the batteries straight or with the lower end first. You would risk breaking the fixing flange so the battery would not be seated securely in the battery compartment. If the batteries are in good condition, the status LED (2b) will continue glowing dimly. When the status LED (2b) illuminates brightly the batteries will be dead within about 90 minutes. Replace the batteries with new ones as soon as possible. Screw the supplied protective ring (2j) and the battery compartment cover back onto the transmitter CW. You can rotate the protective ring (2j) so that any one of the controls will be accessible and all others covered (B to E) and thus protected from being misadjusted unintentionally. Note: For easy channel identification in a multichannel setup, you can install a different-color protective ring included in the optional Color Coding Kit. These protective rings are adjustable, too. Note: If you prefer to cover all controls, reinstall the original color code ring (2d) after adjusting the system as described in section 9. [. . . ] There should always be a direct line of sight between the transmitter and receiver. 5 m) away from any equipment that may emit RF radiation such as lighting racks, fluorescent lamps, digital effects units, or PCs. You can either use the receiver free-standing or mount it in a 19" rack using the supplied RMU 80 rack mounting kit. Slide a rack ear into the fixing rail on one side of the receiver and the BP 80 blank panel into the fixing rail on the other side from rear to front. [. . . ]