User manual ROLLEI FLEXLINE 140

[. . . ] FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] An [ ] icon is displayed with images that have been recorded with a voice memo. Playing back voice memo A press of the button displays [VOICE PLAYBACK] and plays back the voice memo. xa E 100- 0001 Voice memo is only available for still images. EN-23 Protecting Images Set the data to read-only to prevent images from being erased by mistake. Select the image that you want to protect with the / buttons. Select [Protect] with the / buttons, and press the button. Select [Single] or [All] with the / buttons, and press button. Select [Set] with the / buttons, and press the button. Protection is applied to the image and the camera returns to the playback mode. The protect icon [ ] is displayed with protected images. When [All] has been selected, [ ] is displayed with all the images. Canceling the Protection To cancel protection for only one image, display the image on which you want to remove the image protection. Select [Protect] with the / buttons from the playback menu, and press the button. Select [Single] or [All] with the / buttons, and press the button. Select [Cancel Protect] with the / buttons, and press the button. The removal of image protection is executed and the camera returns to the playback mode. Formatting an SD/SDHC memory card overrides protection, and erases all images regardless of their protected status. EN-24 DPOF Settings DPOF is the abbreviation for Digital Print Order Format, which allows you to embed printing information on your memory card. You can select the images to be printed and how many prints to make with the DPOF menu in the camera and insert the memory card to the card compatible printer. When the printer starts printing, it will read the embedded information on the memory card and print the specified images. Select the image that you want to set DPOF with the / buttons. Select [DPOF] with the / buttons, and press the button. Select [Single] or [All] with the / buttons, and press the button. [Single]: Sets DPOF for each individual image. [All]: Sets DPOF for all images at once. Select [Print Num. ] with the / buttons, and press the button. This displays the number of prints setting screen. Set the number of prints with the / buttons, and press the button. [. . . ] Select [Print] with the / buttons, and press the button to start printing. 6. The printing starts and the figure shown on the right hand side appears. [COMPLETE] will be displayed temporarily, reminding you that the printing procedure is finished. If an error is detected during the connection (i. e. [. . . ]