User manual ROLLS MP110

[. . . ] SPECIFICATIONS Frequency Response THD: EIN (SMPTE): Attenuation: Noise Floor: Connectors: Input Impedance: Output Impedance: Maximum Input Level: Max Output Level: Maximum Gain: Size (WxHxD) Weight: Power: 20Hz - 40kHz, +/- 3dB Mic/Line 5Hz - 40kHz inst. . 1% typical -129 dB 20 dB -90dB XLR balanced and 1/4" unbalanced In and Out 600 balanced, 10M line 100 bal. , and unbal. +20 dB +11 dB +70db 7 5/8" x 1 5/8" x 5 3/8" 194 mm x 40 mm x 135 mm 2. 5 lbs (1. 135 Kg) 12VAC 300ma MP110 DIRECT DRIVE Tube Mic Preamp Tube Mic Preamp CLIP PWR LIMITED WARRANTY This product is warranted to the original consumer purchaser to be free from defects in materials and workmanship under normal installation, use and service for a period of one (1) year from the date of purchase as shown on the purchaser's receipt. [. . . ] This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. 20 dB PAD PHANTOM PWR +17 GAIN +75 -O 0 O VOLUME PHASE REVERSE MP110 OWNERS MANUAL Bellari is a division of ROLLS Corporation Salt Lake City, UT Thank you for your purchase of the Bellari MP110 DIRECT DRIVE Tube Mic Preamp. We recommend that you take a moment and read this manual as it provides information that will help you in using your unit to it's fullest potential. The MP110 provides clear sonic quality and performance for the working musician, studio operator or anyone who needs a preamp with the warm, smooth, analog sound. The unit uses a premium 7025 tube in a unique configuration to give smooth controllable gain. The unit has both XLR and 1/4" inputs and outputs with a 20 dB Pad and a Phase Reversal switch to adapt to any performing or studio situation. Unpack and Inspect the MP110 package Your MP110 was carefully packed at the factory in a protective carton. Nonetheless, be sure to examine the unit and the carton for any signs of damage that may have occurred during shipping. If obvious physical damage is noticed, contact the carrier immediately to make a damage claim. We suggest saving the shipping carton and packing materials for safely transporting the unit in the future. Complete the Warranty Registration Card and return it to the factory. FRONT PANEL DESCRIPTION Tube Mic Preamp CLIP PWR REAR PANEL DESCRIPTION MODEL MP110 MADE IN USA INST. INPUT 12 VAC 300mA OUTPUT CORPORATI ON SERIAL NUMBER 110MIC/LINE INPUT INPUT: 1/4" unbalanced and XLR balanced jacks for receiving incoming signals. OUTPUT: 1/4" unbalanced and XLR balanced jacks for sending outputting the signal to a recording device, mixer, amplifier, etc. EXAMPLE Shown below is an example application for the DIRECT DRIVE. Connect a microphone (dynamic or condenser) to the Mic Input, and an XLR or 1/4" cable to the Output. Connect the Output cable to a recording device. [. . . ] PWR LED: Indicates power is applied to the MP110. Tube Mic Preamp CLIP PWR 20 dB PAD PHANTOM PWR +17 GAIN +75 -O 0 O VOLUME PHASE REVERSE MP110 ATTENTION - DISTORTION POSSIBLE: The output stage of the MP110 may be overdriven by increasing the VOLUME control. This will cause a more harsh distortion than that of overdriving the tube circuit. This may or may not be a desired effect. 1 2 3 4 5 6 7 8 REWIND FAST FWD STOP PLAY RECORD EJECT [. . . ]