User manual ROLLS MS19

[. . . ] LIMITED WARRANTY This product is warranted to the original consumer purchaser to be free from defects in materials and workmanship under normal installation, use and service for a period of one (1) year from the date of purchase as shown on the purchaser's receipt. The obligation of Rolls Corporation under this warranty shall be limited to repair or replacement (at our option), during the warranty period of any part which proves defective in material or workmanship under normal installation, use and service, provided the product is returned to Rolls Corporation, TRANSPORTATION CHARGES PREPAID. [. . . ] IN NO EVENT SHALL WE BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental or consequential damages so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. MS19 Mic Combiner LIFT GROUND MS19 Mic Combiner · Combines 2 balanced XLR inputs to a balanced XLR output: One hard-wire "pass-through" One transformer balanced MIC COMBINER MS19 · Ground Lift switch for noise elimination The MS19 Mic Combiner is essential for properly combining two balanced signals to a single output. An example application is combining two dynamic microphones to a single channel on a mixing console. OWNERS MANUAL Rolls Corporation Salt Lake City, UT 11/00 Thank you for your purchase of the MS19 Mic Combiner. This unit was designed to combine two balanced XLR signals, one direct - one transformer isolated, to one single XLR output signal. A ground lift switch has been provided to eliminate some cases of hum caused by ground loops. Unpack and Inspect the MS19 package Your MS19 was carefully packed at the factory in a protective carton. Nonetheless, be sure to examine the unit and the carton for any signs of damage that may have occurred during shipping. If obvious physical damage is noticed, contact the carrier immediately to make a damage claim. We suggest saving the shipping carton and packing materials for safely transporting the unit in the future. [. . . ] GROUND LIFT: Switch when in "GROUND" position, indicates that pins 1 of the INPUTS and OUTPUT jacks are connected. In the "LIFT" position, the grounds have been separated. LIFT GROUND OPERATION Shown below is an example of how to connect your MS19. TO MIXER LIFT GROUND MIC COMBINER MADE IN USA MS19 MIC COMBINER MS19 SPECIFICATIONS Input Impedance: Output Impedance: Dimensions: Weight: 600 Ohms 600 Ohms 3 x 2. 25 x 1. 2 inches 8 Ounces [. . . ]