User manual ROLLS MX54S PROMIX PLUS

[. . . ] MX54s ProMix Plus - Mixes three microphones to stereo XLR outputs - Output level controls for mic or line-level output - Transformer isolated outputs - Phantom Power and Low-Cut switches for each Mic input - Battery and AC powered The MX54s is a very useful microphone mixer. It's perfect for sub-mixing microphones in an installation or recording application. The Phantom Power and Low-Cut switches add to the versitility and usefullness of the MX54s. This product is warranted to the original consumer purchaser to be free from defects in materials and workmanship under normal installation, use and service for a period of one (1) year from the date of purchase as shown on the purchaser's receipt. [. . . ] This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. 3-Channel Stereo Mic Mixer ProMix Plus MX54s LIMITED WARRANTY SPECIFICATIONS Input Impedance: Output Impedance: THD + Noise: S/N Ratio: Frequency Response: Max Output Level: Max Input Level: Max Gain: Low Cut: Current Draw: Phantom Power: Connectors: Size: Weight: Rolls Corporation Salt Lake City, UT 10/00 600 Ohms XLR 600 Ohms . 02% 84 dB 25 Hz - 16 kHz (+0 / -3 dB) + 14 dB -14 dB +60 dB -3 dB @ 100 Hz 20 mA +18 VDC 3 Female XLR, 2 Male XLR, 1 1/4" TRS, DC Power Jack 5. 3" x 3. 7" x 2" 1 lbs. Owners Manual INTRODUCTION Thank you for your purchase of the MX54s ProMix Plus. This unit is designed and manufactured to mix three microphones together and send their combined signals out stereo transformer-balanced XLR outputs. The individually switchable phantom power and low-cut switches provide he final touches which make the MX54s a valuable tool for any sound reinforcement, musical, recording, or install application. Unpack and Inspect the MX54s package Your MX54s was carefully packed at the factory in a protective carton. Nonetheless, be sure to examine the unit and the carton for any signs of damage that may have occurred during shipping. If obvious physical damage is noticed, contact the carrier immediately to make a damage claim. We suggest saving the shipping carton and packing materials for safely transporting the unit in the future. Please complete the Warranty Registration Card and return it to the factory. DESCRIPTION REAR PANEL Mic Input: 1 - 3: XLR balanced inputs for connection to any standard dynamic or condenser microphone. Right and Left Outputs: Transformer balanced XLR output jacks for connection to the next device in the signal chain such as a signal processor or amplifier. Right and Left Trim controls: Screwdriver adjustable controls to vary the level of each output. NOTE: These controls are set at mic level from the factory. Turning them counter-clockwise increases the output level. These controls do not effect the Aux/Headphone Output. [. . . ] LOW CUT ON=UP Also on the left side are the Phantom Power and Low-Cut switches. PLPLPL As shown here, under each number is a P indicating Phantom Power, and an L which indicates Low-Cut. When the P switch is DOWN, the phantom power is ON, when it is UP , the phantom power is OFF. When the L switch is UP the low-cut is ON, , when it is DOWN, the low-cut is OFF. [. . . ]