User manual ROMMELSBACHER CT 2005/IN

[. . . ] CT 3405/IN Control panel for left cooking zone Control panel for right cooking zone A) "heat" for residual heat indication B) , , power" für Betrieb im Modus Leistungsstufen b) "power" for operating in power level mode C) , , temp" für Betrieb im Modus Temperaturstufen c) "temp" for operating in temperature level mode D) , , timer" für Betrieb mit Laufzeiteinstellung d) "timer" for operating with timer setting Getting acquainted with your appliance. 19 General notes for cooking with induction. 24 Setting the operating time (timer) from 1 up to 180 minutes. 24 Setting the operation time (timer) ­ reset function. [. . . ] Tip: Check by means of a magnet whether the pot bottom is suitable. If the magnet clings to the outside of the pot bottom, the vessel is qualified for induction cooking. Touch control sensors The appliance is equipped with touch control sensors which grant an easy and convenient handling. Touching the sensor with your finger activates the relevant function and an acoustic acknowledgement signal. NOTE: Always keep the control panel clean and dry. Do not touch it with fingers wet and do not use it as a shelf of deposit as this might lead to malfunctions. Residual heat indicator Each cooking zone is equipped with a residual heat indicator which shows whether the cooking zone is still hot. If the temperature of the cooking zone has reached a value of more than 80 °C due to the waste heat emitted by the pot, the LED "heat" (8a) will glow. As soon as the temperature has dropped below 80 °C or the appliance is disconnected from the mains, the LED "heat" (8a) goes out. Pot recognition Each cooking zone features a sensor which recognizes whether there is a vessel on the cooking zone. If no suitable vessel is recognized on the cooking zone after switch-on, the display (4) will show "E0" and an alternate warning signal will sound. If no pot is recognized within 45 seconds, the appliance will switch automatically into the standby mode. If a pot is removed from the cooking zone during operation, the display (4) will show "E0" and an alternate warning signal will sound. If a pot is replaced within 45 seconds, the cooking process will continue with the level last set and an operating time that might have been set before will continue to run. However, if no pot is recognized within 45 seconds, the appliance will switch automatically into the standby mode. Fan After switch-on an inside fan starts working, which cools the interior parts of the appliance in order to prevent the appliance from overheating. It is normal for the fan to continue running in the standby mode after a long operation time. Operating time restriction The operating time restriction will cause the cooktop to switch automatically in the standby mode if the settings have not been changed for a period of 2 hours. This happens independently of the respectively set level. After an automatic switch-off the cooking plate can be turned on once again and the maximum operating time will be active again. In case the operating time (timer) is set for a period of more than 2 hours, this setting takes priority. The appliance switches off automatically after the set time has elapsed. [. . . ] If no suitable vessel is recognized on the cooking zone after switch-on, the display will show "E0". Self help: Place a pot on the cooking zone within 45 seconds; otherwise the electronics will switch the unit into the standby mode. (Also refer to point "Getting acquainted with your appliance") E1 Electronic error: A short-circuit has occurred in an electronic circuit of the appliance. Self-help: Not possible ­ the appliance must be forwarded to the customer service at any rate. [. . . ]